User manual HASBRO MY LITTLE PONY GAME 41519

[. . . ] It may smoke and smell – this is normal and will cease after a short while. 6. If necessary, carefully clean the soleplate down with a dry, folded cloth Cleaning and Maintenance Attention !For general cleaning, follow the information below: Problem Dirty/lightly marked iron body or soleplate Mark develops on soleplate during use Solution Clean body of iron or soleplate with a damp cloth then dry it. Set the iron to its maximum temperature setting. [. . . ] If it is absolutely necessary to use an extension cable, make sure that it is suitable for 16A and has a socket with an earth connection. • The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again. • Do not allow the power cable to come into contact with the soleplate when it is hot. • In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. 27Ω . If necessary, the user can ask the public power supply company for the system impedance at the interface point. • This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. • Keep the appliance out of children’s reach. • Children should be supervised to ensure that they do not play with the appliance. • Remove the plug from the socket before filling the appliance with water or before pouring out the remaining water after use. • The appliance must never be placed under the tap to fill the water tank. It cannot be used on a synthetic setting for delicate items. Do not vertical steam while the item is being worn. Never spray or aim steam at people or animals!1. Make sure that there is water in the tank (I). 2. Set the temperature control (J) to the «•••» or «max» position and the steam regulator (A) to its maximum position. 3. Hold the iron in an upright position about 15 cm away from the garment being steamed. 4. Press the shot of steam button (C) on the handle at intervals of 5 seconds, however, after 4 jets of steam, wait for 10seconds to allow for continued steam production. I. Filling the water tank unplug the iron from the mains!1. Place the iron at an angle of 45º 2. Fill the tank but never above the “max” mark Use only clean water from the tap without mixing anything with it. The addition of other liquids, such as perfume or fraganced ironing water, will damage the appliance. Do not use condensed water from tumble dryers, air conditioners or similar appliances. [. . . ] 3. After the necessary warm-up period, unplug the iron. 4. Hold the iron over a sink and turn the steam regulator (A) to the “calc´n clean” position and keep it at this position. Boiling water and steam will come out of the soleplate (F), carrying scale or deposits that might have built up there. When the iron stops dripping, position the steam regulator to the position 6. For improved de-scaling, heat up the iron again fully, and press the shot of steam button (C) several times in quick succession. [. . . ]