User manual HASBRO MY LITTLE PONY GAME 41519 SPANISH

[. . . ] The iron begins to smoke when switched on. Deposits come out through the holes in the soleplate Flashing lamp on top of handle (*) No water in the tank. During first use: Certain components on the appliance have been lightly greased at the factory and may produce a little smoke when initially heated. Always empty the tank after ironing and set the steam regulator to after ironing and when filling the tank Mix distilled water with tap water as directed in the “Filling the water tank” section and never add any other products to the water tank Add water to the water tank. Contact an Authorised Technical Service Centre. [. . . ] Carefully read through the operating instructions for the appliance and safeguard them for future reference. General safety warnings • Danger of electric shocks or fire!• This appliance is to be connected and used in accordance with the information stated on its characteristics plate. • This appliance must be connected to an earthed socket. If it is absolutely necessary to use an extension cable, make sure that it is suitable for 16A and has a socket with an earth connection. • The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again. • Do not allow the power cable to come into contact with the soleplate when it is hot. • In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. 27Ω . If necessary, the user can ask the public power supply company for the system impedance at the interface point. • This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. 2. Fill the water tank (D) via the water tank inlet but never above the “max” mark (F). Use only clean water from the tap without mixing anything with it. The addition of other liquids, such as perfume, will damage the appliance. Any damage caused by the use of the aforementioned products, will make the guarantee void. Do not use condensation water from tumble dryers, air conditioners or similar appliances. This appliance has been designed to use normal tap water. To prolong the optimum steam function, mix tap water with distilled water 1:1. If the tap water in your district is very hard, mix tap water with distilled water 1:2. You can inquire about the water hardness with your local water supplier. Set the steam regulator (A) to the position and This can be used to remove stubborn wrinkles or to press in a sharp crease or pleat. It cannot be used on a synthetic setting for delicate items. 1. Set the temperature control (H) to the “•••” or “max” position. [. . . ] Once the iron is ready, you can continue to iron even if the pilot lamp comes on again. 6. If your iron has auto shut-off and the pilot light (K) is flashing, the auto shut-off has activated. Gently move the iron side to side to restart it. Multiple de-scaling system This range of irons is equipped with the following descaling features “AntiCalc”. [. . . ]