User manual HASBRO MY LITTLE PONY PARADISE ESTATE

[. . . ] Children must never play with the appliance Cleaning and user maintenance must never be carried out by children without supervision. The vacuum cleaner may not be used for: cleaning persons or animals vacuuming up: – hazardous, sharp-edged, hot or red hot substances. – damp or liquid substances – highly flammable or explosive substances and gases – ash, soot from tiled stoves and central heating systems – toner dust from printers and copiers. Keep suction away from your head when using the handle, nozzles or pipe. Stand the appliance on a firm, secure surface when vacuuming. [. . . ] When vacuuming stairs, the appliance must always be lower down than you. In the following cases, stop using the appliance immediately and contact the after-sales service: – if the mains connection cable is damaged. – if you have accidentally vacuumed up some liquid or liquid has entered the inside of the appliance – if the appliance has been dropped. Do not use the power cord to carry the vacuum cleaner. Fully extend the power cord when using the vacuum cleaner continuously for several hours. When disconnecting the appliance from the mains, pull on the plug, not the power cord. Do not pull the power cord around sharp corners or allow it to become trapped. Unplug the power cord from the mains before carrying out any work on the vacuum cleaner or its accessories. Do not use the vacuum cleaner if it is damaged. Unplug the power cord from the mains if a fault is detected. For safety reasons, only authorised after-sales service personnel are permitted to carry out repairs and fit replacement parts to the vacuum cleaner. Low suction range => For vacuuming delicate fabrics, e. g. Medium suction range => For daily vacuuming of lightly soiled floors. High suction range => For vacuuming durable floor coverings, hard floors and for heavily soiled surfaces. 8 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 9 Vacuuming Adjusting the floor tool: Rugs and carpets hard floors => => Caution!Floor tools are subject to a certain amount of wear, depending on the type of hard floors you have (e. g. Therefore, you must check the underside of the floor tool at regular intervals. Worn undersides of floor tools may have sharp edges that can damage sensitive hard floors, such as parquet or linoleum. The manufacturer does not accept any responsibility for damage caused by worn floor tools. Remove the upholstery nozzle and crevice nozzle from the accessories holder as illustrated. Vacuuming with accessories Attach the nozzles to the tube or handle as required: Crevice nozzle for vacuuming crevices and corners, etc. Upholstery nozzle for vacuuming upholstered furniture, curtains, etc. 9 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 10 Vacuuming After use, push the crevice nozzle and upholstery nozzle back into the accessories holder as indicated. CLICK! You can use the parking aid on the back of the vacuum cleaner if you wish to stop vacuuming for a short time. Once you have switched off the vacuum cleaner, slide the catch on the floor tool into the recess on the rear of the appliance. The appliance can also be carried using the carrying handle when vacuuming steps, for example. 10 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 11 When the work is done 16 Unplug the vacuum cleaner. The cable then rewinds automatically. To store/ transport the vacuum cleaner, use the storage aid on the underside of the vacuum cleaner. Slide the catch on the floor tool into the groove on the underside of the appliance. To remove the flexible hose, press the two lugs together and pull the tube out. 11 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 12 Changing the dust bag and filters Replacing the dust bag If the dust bag change indicator is completely yellow when the floor tool is lifted from the floor and the highest suction power is selected, the dust bag must be changed, even if it is not yet full. In this case it is essential to change the dust bag due to the type of material it contains. [. . . ] In this case it is essential to change the dust bag due to the type of material it contains. First check that the nozzle, suction pipe and flexible hose are not blocked, as this would also lead to the dust bag change indicator being triggered. The handle can easily be detached from the hose to remove blockages. Opening the lid Press the control button down to the stop and leave it retracted in the appliance. !Caution: Only open the lid with the control button retracted. Open the lid by moving the locking lever in the direction of the arrow. 12 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 13 Changing the dust bag and filters Seal the dust bag by pulling the sealing strip and remove the bag. Slide the new dust bag into the holder to the stop. !Caution: the lid will only close if a dust bag has been inserted. Cleaning the motor protection filter The motor protection filter should be cleaned regularly by knocking out the dirt or rinsing it out. Open the dust bag compartment lid. Pull out the motor protection filter in the direction of the arrow. 13 5100 003 184 A 30. 11. 2011 11:15 Uhr Seite 14 Changing the dust bag and filters Clean the motor protection filter by tapping it. If it is very dirty, the motor protection filter should be rinsed out. [. . . ]