User manual HASBRO MYSTERY MANSION 1996

[. . . ] The socket must only be installed and the connecting cable must only be replaced by a qualified electrician, and in accordance with the appropriate regulations. If the plug is no longer accessible following installation, an allĆpin isolating switch must be present on the installation side with a contact gap of at least 3 mm. [. . . ] Contact protection must be guaranteed by the installation. Great Britain and Australia: The appliance is designed for permanent connection to a 3Ćwire cable. The appliance must only be connected by a qualified electrician in accordance with the wiring diagram attached to the connecting cable. An allĆpole disconnecting device must be present on the installation side with a contact gap of at least 3 mm in order to comply with current safety regulations. In accordance with heating testing standards, the appliance corresponds to Safety Class Y". The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live Do not connect the appliance using a 13A plug or protect it with a 13A fuse. Fitted units The fitted cabinet must not have a rear wall behind the appliance. 4 J Insert the oven and align centrally. J Secure the oven with screws (4 x 25) J The gap between the work surface and the oven must not be sealed by addiĆ tional strips. Removal Disconnect the cooker from the power supply. Lift the cooker slightly and pull it out completely. Oven under the work surface - Fig. 1 There must be a ventilation cutĆout made in the intermediate floor of the surround cabinet Ć see Fig. If the oven is being installed beneath a hob, observe the hob assembly instructions. Appliance in the high cabinet - Fig. 2 The appliance must be installed above a fanĆassisted oven made by the same manufacturer. [. . . ] 2 The appliance must be installed above a fanĆassisted oven made by the same manufacturer. Installation above a refrigerator is possible. Corner installation - Fig. [. . . ]