User manual HASBRO NERF INDOOR GOLF PUTTING SET

[. . . ] 7 Switching off water softening system . 8 Switching off rinse aid refill indicator . 16 Express Wash/ Speed Perfect (VarioSpeed) . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. [. . . ] The expected programme duration flashes on the digital display H. The programme starts running. Ï Intensive zone * vsIniezot ne Perfect for a mixed load. You can wash very soiled pots and pans in the lower basket together with normally soiled utensils in the upper basket. The spray pressure in the lower basket is intensified, the rinsing temperature is increased slightly. Remaining running time display When the programme is selected, the remaining running time of the programme is indicated on the digital display H. The running time is determined during the programme by the water temperature, the number of utensils as well as the degree of soiling and may vary (depending on the selected programme). ¿ Extra drying * nxEtradigy An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. 16 en nargoTiep m Timer programming * * depending on model You can delay the start of the programme in 1-hour steps up to 24 hours. – Press button P until the digital display H jumps to : . – Press button P until the displayed time corresponds with your requirements. – Press START button @, timer programming is activated. – To delete the preselected starting time, press the button P until is indicated on the digital display. You can change your programme selection at any time until the programme starts. To change the setting: – Rotate programme selector 8 until the required value is indicated on the digital display H. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. Changing the programme When the START button @ has been pressed, the programme cannot be changed. The only way a programme can be changed is by Cancel programme (Reset). Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Close the door. – Press and hold down the START button @. – Rotate programme selector 8 until : is indicated on the digital display H. The factory-set value : is lit on the digital display H (intensive drying off). Change the setting as follows: – By rotating the programme selector 8, you can switch intensive drying on : or off : . The set value is saved. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid – Check the refill indicators h and `. If required, refill salt and/or rinse aid. 18 en Filters The filters 1R keep large foreign objects in the rinsing water away from the pump. These foreign objects may occasionally block the filters. [. . . ] See rating plate for required fusing 92. – The socket must be near the appliance and freely accessible following installation. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. – The connection may be modified by technicians only. [. . . ]