User manual HASBRO NERF MAX FORCE RAZOR BACK

[. . . ] Do not lift by projecting components (e. g. – In addition to the instructions mentioned here, special regulations of the relevant water and power supply companies may apply. – If in doubt, have the appliance connected by a technician. – Lay hoses and cables in such a way that there is no risk that they can be tripped over. Installation area – – – – Stability is important to prevent the machine from wandering. [. . . ] Leave the detergent drawer open so that residual water can evaporate. Drum Leave the washer dryer door open after washing so that the drum can dry. Rust stains – use chlorine-free cleaning agent, not steel wool. Contents Safety instructions . . Descaling To prevent unused detergent from flowing into the outlet during the next wash: Pour 1 litre of water into dispenser II and start the Empty (Drain) or Spin programme. No laundry in the machine!This is not necessary if the detergent is dosed correctly. However, if it is necessary, follow the instructions of the descaler manufacturer. Suitable descaling products can be purchased from our website or after-sales service. Filter in the water inlet hose Risk of electric shock Do not immerse the Aqua-Stop safety device in water (it contains an electric valve). Reduce the water pressure in the supply hose: Technical specifications Dimensions (width x depth x height) Weight 600 x 600 x 850 mm 84, 5 kg Nominal voltage 220–240 V, 50 Hz Max. drying power 1900 W 100–1000 kPa (1–10 bar) 60–100 cm According valid European Standard EN50229 After-sales service If you cannot rectify the fault yourself Operating instructions, page 12, 13: What to do if. . . , please contact our after-sales service. We will always find a suitable solution and will avoid a visit from a service technician wherever possible. The contact details for all countries can be found in the enclosed after-sales service directory. Please give the after-sales service the product number (E-Nr. ) and the production number (FD) of the appliance. 60 cm e 1 2 Removing transport bolts – Before using the appliance for the first time, always remove and retain all 4 transport bolts. – If transporting the appliance subsequently, always re-install the transport bolts – this prevents damage to the machine. Page 6 – Retain the screw and sleeve. Take the hoses out of the holder and the elbow. Water connection – Risk of electric shock!Do not immerse the Aqua-Stop safety device in water (contains an electric valve). – To prevent leakage or water damage, follow the instructions in this chapter. – Attention: operate the washer dryer with cold drinking water only. Do not connect to the mixer tap of a pressureless hot-water heater. Only use the inlet hose supplied or one which was purchased from an authorised specialist dealer. – If in doubt, have the appliance connected by a technician. Water supply Water inlet hose: Attention: do not kink, crush, modify or cut through (strength is no longer guaranteed). Optimum water pressure in the mains: 100–1000 kPa (1–10 bar) – When the tap is turned on, the water flow is at least 8 l/min. [. . . ] Remove foreign objects/loose debris/fluff from inside and clean the pump. (impeller in the pump must be able to rotate). Clean any residual lye or fluff from the thread of the pump cap and pumphousing. 3. Clean the fluff on the air inlet filter with water and a brush. 4. [. . . ]