User manual HASBRO NERF N STRIKE VULCAN EBF 25

[. . . ] Do not lift the machine by any of its projecting parts (e. g. – In addition to the instructions mentioned here, special regulations regarding the relevant water and power supply companies may apply. – If in doubt, have the appliance connected by a technician. – Lay hoses and cables in such a way that there is no risk of tripping. Removing the packaging Please remove the bottom foam and also foam support from the bottom of appliance when you are removing the packaging! Removing the transport bolts – Before using the appliance for the first time, always remove and retain all 4 transport bolts from the back of appliance. [. . . ] The mains voltage must correspond to the voltage specification on the washing machine (rating plate). The connected load and required fuse or line protecting cut-out are indicated on the appliance rating plate. Transportation, e. g. Before transporting the washing machine: 1. Release the water pressure in the water inlet hose. > Instruction manual : Filter in the water inlet hose. > Instruction manual : Detergent solution pump. Isolate the washing machine from the power supply. Remove the hoses. Washing machine en Use a spirit level to align the washing machine. 1. Use a spanner to loosen the lock nut in a clockwise direction. Lock nut Appliance foot Ensure that: – the mains plug and socket are compatible, – the cable cross-section is adequate, – the earthing system has been installed correctly. 2. Adjust the height by turning the appliance foot. Do not install the washing machine outdoors and/ or in areas where there is a risk of frost. – The washing machine may be damaged. Do not lift the machine by any of its projecting parts (e. g. – In addition to the instructions mentioned here, special regulations regarding the relevant water and power supply companies may apply. – If in doubt, have the appliance connected by a technician. – Lay hoses and cables in such a way that there is no risk of tripping. Removing the packaging Please remove the bottom foam and also foam support from the bottom of appliance when you are removing the packaging! Standard accessories Environmentally-friendly disposal – Dispose of packaging in an environmentally friendly manner. – This appliance has been identified in accordance with the European Directive 2002/96/ EEC on Waste Electrical and Electronic Equipment (WEEE). This directive specifies a framework for the return and recycling of waste appliances, and is valid throughout Europe. – – – – – Water inlet hose. Elbow for attaching the water drainage hose e. g. Covers for holes left by removing the transport bolts. Depending on the connection – A 24-40 mm dia. [. . . ] Adjust the height by turning the appliance foot. All four appliance feet must be placed firmly on the floor. The washing machine must not be able to shake. Use a spirit level to check the alignment of the washing machine and correct it if necessary. A damaged power cord must be replaced by an electrician only. [. . . ]