User manual HASBRO NEW KIDS ON THE BLOCK-AMFM RADIO

[. . . ] 7 Switching off water softening system . 8 Switching off rinse-aid refill indicator . 12 Information about comparability tests 12 Additional options . 13 en Safety instructions Delivery ­ Check the packaging and dishwasher immediately for damage caused in transit. [. . . ] This additional option is ideal for cleaning e. g. chopping boards and baby bottles. ¿ Extra drying * An increased temperature during the final rinse and an extended drying phase ensure that even plastic parts dry better. There is a slight increase in the energy consumption. Switching on the appliance ­ Turn on the tap fully. ­ Rotate programme selector 0 to the required programme. he programme starts running. 13 en Timer programming * * depending on model You can delay the start of the programme by 3, 6 or 9 hours. ­ Keep pressing the Preselected starting time button @ until the appropriate display 3h, 6h or 9h is lit. ­ Press START button 8, timer programming is activated. ­ To delete the preselected starting time, keep pressing the Preselected starting time button @ until none of the displays 3h, 6h or 9h is lit. You can change your programme selection at any time until the programme starts. Terminating the programme (Reset) ­ Press START button 8 for approx. ­ The remaining programme sequence lasts approx. Switch off ON/OFF switch (. Changing the programme When the START button 8 has been pressed, the programme cannot be changed. Never use a steam cleaner to clean your dishwasher. The manufacturer is not liable for any consequential damage. Regularly wipe the front of the appliance and fascia with a damp cloth; water and a little washing up liquid are adequate. Do not use sponges with a rough surface or abrasive detergents, as these could scratch the surfaces. Stainless steel appliances: To prevent corrosion, avoid using sponge cloths or wash them out thoroughly several times before using for the first time. ã=Warning Never use other chlorinated household detergents!Health hazard! Special salt and rinse aid ­ Check the refill indicators X and P. If required, refill salt and/or rinse aid. ­ Remove any residue and clean filters under running water. ­ Re-install filter system in reverse sequence and ensure that the arrow marks are opposite each other after closing the filter system. 15 en Spray arm Limescale and dirt from the rinsing water may block nozzles and the bearing assemblies of the spray arm 1". ­ Check outlet nozzles on the spray arm for blockages. ­ Remove the spray arm upwards. Waste water pump Large food remnants in the rinsing water not retained by the filters may block the waste water pump. The rinsing water is then not pumped out and covers the filter. [. . . ] 20 en Removing the appliance Also observe the sequence of worksteps here. ­ Disconnect the appliance from the power supply. ­ Disconnect the waste water and fresh water connections. ­ Pull out the appliance, carefully pulling the hose behind. Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. [. . . ]