User manual HASBRO OPERATION 2004

[. . . ] Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. The units next to the appliance must be made of non-flammable materials. The laminated covering and glue for adhering it must be heat resistant. This appliance cannot be installed above fridges, washing machines, dishwashers or similar. [. . . ] If the hob is electric or mixed (gas and electricity) and there is no oven below, place a non-flammable separator (e. Metal or plywood) 10 mm from the bottom of the hob. This will prevent access to the base of the hob. If the hob is gas, it is recommendable to place the separator at the same distance. On wood work surfaces, varnish the cutting surfaces with a special glue. This protects them from moisture which could collect under the work surface. installation of appliance A) Standard installation (fig. 3a) Depending on the model, the adhesive seal may be factory-fitted. If this is the case, it should not be removed under any circumstances, since the adhesive seal prevents leaks. If the seal has not been factory-fitted, apply it to the underside of the hob. Fitting the appliance onto the kitchen unit: 1. If you need to make a cylindrical connection, replace the factoryfitted L-tube with the one in the accessory bag. Depending on the gas to which your appliance is going to be adapted, see table III, carry out the corresponding action: A: firmly tighten the by-pass screws. B: loosen the by-pass screws until the gas flow from the burners is correct: when adjusting the control knob between maximum and minimum, the burner does not go out, nor is there a flame backdraught created. C: the by-pass screws need to be changed by an authorised engineer. If the by-pass screw cannot be accessed, disassemble the grease drip tray, which is fitted to the hob with a series of screws. The following steps must be taken to remove it: 1. To reinstall the appliance, proceed in the reverse order to disassembly. all valve reinforcing rings must be in position to ensure watertightness. These devices are essential for the correct operation of the appliance as they prevent liquids and dirt from entering the appliance. In the event of a malfunction, change the whole tap. After finishing, the sticker indicating the new type of gas must be placed close to the specifications plate. [. . . ] Provide an omnipolar cut-off switch with a minimum contact opening of 3 mm (except for plug connections, if the user has access to it). This appliance is type “Y”: the supply cable can only be changed by the Technical Assistance Service and not the user. The cable type and minimum cross-section must be respected. Changing the gas type If the country's regulations allow, this appliance can be adapted to other types of gas (see specifications plate). [. . . ]