User manual HASBRO OPERATION SIMPSONS EDITION SPANISH

[. . . ] The selected setting is saved. °Clarke 0-8 9-20 * only before the first wash or if the water hardness has been changed 21-26 27-44 Hardness range soft medium hard hard mmol/l 0-1. 1 1. 2-2. 9 3. 0-3. 7 3. 8-6. 2 Setting 0 1 2 3 , End 6 2 Filling the salt dispenser Dissolves limescale (not necessary for set value 0!) . . . Unscrew cover. Fill the salt dispenser with water before the first wash only. Add special salt (never add detergent!). [. . . ] Add special salt (never add detergent!). Wash immediately. 3 4 6 $ Adding rinse aid Spick and span . . . 2 Press mark 1, lift up cover 2. Fill in rinse aid. Screw on the cover. CLICK! 1 % If required, open the cover (press button). Attention: Combination products are not suitable for all programmes, follow manufacturer's instructions. Adding detergent A lot of dirt, a lot of detergent . . . 5 9000 438 519 (8905) 550 EA Switching on the appliance 50 ml 25 ml 15 ml Pour detergent into the dry detergent dispenser only. Slide cover shut, press. PLOP! 7 Select programme Quick, economical or intensive . . . Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Start Intensive 70° Normal 65° Eco 50° Gentle 40° Quick 45° Prerinse ±² ÙÚ 2:00 0, 90 9 2:20 0, 80 8 áà é ê 2:40 0, 63 7 1:15 0, 45 7 ñð 0:29 0, 45 6 ù ø Duration: hs : mins The programme data has been measured in the laboratory according to European standard EN 50242. Energy consumption in kWh Deviations are possible in practice. Install supply hose without kinks. More information can be found in the operating instructions Possible causes Supply fitting jammed or calcified Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Remedial action Separate the utensils, prevent contact points. Follow manufacturer's instructions (detergent). Arrange the utensils so that the spray arms can rotate freely. Waste water hose is blocked or kinked Cover not attached to waste water pump Install waste water hose without kinks. Stains and streaks Rinse aid dosage too high/too low Streaks: reduce dosage. Water or limescale stains: increase dosage. Utensils not dry Rinse aid The combined detergent used has a poor drying performance Appliance setting Milky deposits on the utensils (can be removed) Milky deposits, glasses cloudy/tarnished (cannot be removed) Water softening system incorrectly set No salt Increase dosage. Activate intensive drying (depending on model). Refill with special salt. Waste water pump blocked Display "6" flashes Appliance has technical defect Call factory customer service (state fault display). [. . . ] Utensils not dry Rinse aid The combined detergent used has a poor drying performance Appliance setting Milky deposits on the utensils (can be removed) Milky deposits, glasses cloudy/tarnished (cannot be removed) Water softening system incorrectly set No salt Increase dosage. Activate intensive drying (depending on model). Refill with special salt. Waste water pump blocked Display "6" flashes Appliance has technical defect Call factory customer service (state fault display). [. . . ]