User manual HASBRO PERFECTION-ELECTRONIC HAND-HELD

[. . . ] Fitting the appliance onto the kitchen unit: 1. Screw each one of the clips into the position indicated so that they are free to rotate. Press the sides of the hob until it is supported around its entire perimeter. The position of the clips depends on how thick the work surface is. [. . . ] Ú Ins tal la tion i ns tru cti on s en Safety precautions Read the appliance instructions before installing and using. The graphics in these Assembly instructions are given as a guide only. The manufacturer is exempt from all liability if this manual's requirements are not complied with. All operations relating to installation, regulation and conversion to other gas types must be carried out by an authorised installation engineer, respecting all applicable regulations, standards and the specifications of the local gas and electricity providers. You are recommended to contact the Technical Assistance Service to convert to another gas type. Before you begin, turn off the appliance's electricity and gas supply. This appliance has been designed for home use only, not for commercial or professional use. This appliance cannot be installed on yachts or in caravans. The warranty will only be valid if the appliance is used for the purpose for which it was designed. Before installing, check that local distribution conditions (gas type and pressure) and the appliance's adjustment are compatible (see table I). The appliance's adjustment conditions are written on the label or the specifications plate. Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. The units next to the appliance must be made of non-flammable materials. The laminated covering and glue for adhering it must be heat resistant. Changing the gas type If the country's regulations allow, this appliance can be adapted to other types of gas (see specifications plate). The components required for this are in the transformation kit supplied (depending on the model) or are available from our Technical Assistance Service. The following steps should be taken: A) Changing the nozzles (fig. Change the nozzles using the spanner code 340847 (code 340808 for double-flame burners or triple-flame burners) provided by our Technical Assistance Service, see table II, taking special care to ensure that the nozzle does not fall when it is removed from or fitted to the burner. Ensure that it is completely tightened in order to guarantee the seal. Primary air adjustment is not necessary with these burners. Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Never remove the valve reinforcing ring. [. . . ] Adjust the minimum ring setting by turning the by-pass screw using a flat head screwdriver. Depending on the gas to which your appliance is going to be adapted, see table III, carry out the corresponding action: A: firmly tighten the by-pass screws. B: loosen the by-pass screws until the gas flow from the burners is correct: when adjusting the control knob between maximum and minimum, the burner does not go out, nor is there a flame backdraught created. C: the by-pass screws need to be changed by an authorised engineer. [. . . ]