User manual HASBRO PICTIONARY JR 2005

[. . . ] 9 Switching off rinse aid refill indicator . 16 Express Wash/ Speed Perfect (VarioSpeed) . 16 en Safety instructions Before you switch ON the appliance Please read the operating and installation instructions carefully. They contain important information on how to install, use and maintain the appliance. [. . . ] Each time the button is pressed, the set value increases by one level; when the value of : has been reached, the display jumps back to : (off). – Press START button )", the set value is saved. – Close the door. Timer programming You can delay the start of the programme in 1 hour steps up to 24 hours. – Press the button ` + until is flaching in the timer programming display X. – Press + or – button until the ` displayed time corresponds with your requirements. – Press START button )", timer programming is activated. – To delete timer programming `, press the + or – button until is indicated on the digital display X. You can change your programme selection at any time until the programme starts. – Close the door. 17 en Automatic switch off after end of programme or interior light* gitlho/iterntfAom hcsua iw Switching off the appliance Short time after the end of the programme: – Open the door. – Turn off the tap (not applicable if AquaStop fitted). – Remove the utensils when they have cooled down. * depending on model To save energy, the dishwasher can be automatically switched off 1 min or 120 min after the programme ends. The only way a programme can be changed is by Cancel programme (Reset). Maintenance and care A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Intensive drying The final rinse uses a higher temperature which improves the drying result. (Caution if utensils are delicate!) – Open the door. – Hold down programme button # and press START button )" until : . . . . The LED for button # flashes and the digital display 8 displays the factory setting : . – Press programme button # until the factory set value : is indicated on the digital display 8. To change the setting, – Press the button 3 to switch the or off : . Intensive drying on : – Press START button )". – Close the door. Overall condition of the machine – Check spray arm for grease and limescale deposits. If you find such deposits: – Fill detergent dispenser with detergent. Start the appliance without utensils in the programme with the highest rinsing temperature. [. . . ] See rating plate for required fusing 92. – The socket must be near the appliance and freely accessible following installation. If the plug is not freely accessible, an allpole disconnector with a contact opening of at least 3 mm must be fitted on the installation side to satisfy the relevant safety instructions. – The connection may be modified by technicians only. [. . . ]