User manual HASBRO PIPEWORKS 1000-2000-3000

[. . . ] Do not lift the appliance by protruding components (e. g. the washing machine door, the cover, the front panel or the outer door in case of deco models). – In addition to the instructions provided in this document, special regulations from the relevant water and electric utility companies may apply. – If in doubt, have a technician connect the appliance. [. . . ] Disconnect the washing machine from the power supply. Dismantle the hoses. Washing machine Aligning the washing machine with a spirit level 1. Loosen the lock nut using a wrench, by turning it in a clockwise direction. 2. Change the height by turning the appliance feet. Caution: all four appliance feet must be firmly on the ground. Check the alignment of the washing machine with a spirit level and adjust if necessary. 2. Preparing and installing transport braces: 1. Remove all covers and store them. Product number Production number Rely on the professionalism of the manufacturer. This will ensure that the repair is carried out by trained service technicians who arrive equipped with genuine spare parts for your appliance. Aqua-Stop warranty only for appliances with Aqua-Stop max. Tighten the lock nut against the housing. In doing so, hold the foot tight and do not adjust its height. – Caution: frozen hoses may rip/burst. Do not install the washing machine in areas exposed to frost or outdoors. – The washing machine could be damaged. Do not lift the appliance by protruding components (e. g. the washing machine door, the cover, the front panel or the outer door in case of deco models). – In addition to the instructions provided in this document, special regulations from the relevant water and electric utility companies may apply. – If in doubt, have a technician connect the appliance. – Lay hoses and cables in such a way that there is no risk of tripping. Scope of delivery depending on model Aqua Stop Aqua Secure & Standard Hot water Moisture inside the drum is due to final testing. Mains cable Water outlet Water inlet Installation surface – The machine must be stable so that it does not move around. – The installation surface must be firm and level. – Soft floors/floor coverings are not suitable. Covers Elbow for fixing the drainage hose in place Adapter 1/2’’-3/4’’ (depending on model) Installation on a pedestal – The feet of the washing machine must be secured with holding brackets*. [. . . ] Caution: the lock nuts on all four appliance feet must be screwed tightly against the housing. 2. In doing so, turn the bend on the hose holders inwards. Tighten the screws. Electrical connection The washing machine must only be connected to an alternating current via a properly installed earthed socket. After transportation, the transport braces must be removed. page 3. To prevent unused detergent from flowing straight into the drain during the next wash: Pour 2 litres of water into compartment II and start the Empty programme. 9000502633 The power supply and voltage indicated on the washing machine (rating plate) must be the same. The connected load and fuse required are specified on the rating plate. [. . . ]