User manual HASBRO PLASKOOL FLASHLIGHT 1994

[. . . ] Smooth the silicone adhesive with a scraper or wet finger moistened with soap and water before it forms a layer. Allow the silicone adhesive to dry before using the appliance. Ú Ins tal la tion i ns tru cti on s en Safety precautions Read the appliance instructions before installing and using. The graphics in these Assembly instructions are given as a guide only. [. . . ] Before installing, check that local distribution conditions (gas type and pressure) and the appliance's adjustment are compatible (see table I). The appliance's adjustment conditions are written on the label or the specifications plate. This appliance can only be installed in a well-ventilated place in accordance with existing regulations and ventilation specifications. The appliance must not be connected to a combustion product removal device. The supply cable must be attached to the unit to prevent it from touching hot parts of the oven or hob. Appliances with electrical supply must be earthed. Do not tamper with the appliance's interior. If necessary, call our Technical Assistance Service. removal of hob Turn off the appliance's electricity and gas supply. Unscrew the clips and proceed in the reverse order to installation. 4) The end of the inlet connection point of the gas hob has a 1/2” (20. If the hob is gas, it is recommendable to place the separator at the same distance. On wood work surfaces, varnish the cutting surfaces with a special glue. This protects them from moisture which could collect under the work surface. 5) Check that the voltage and power of the appliance are compatible with the electrical installation. The hobs are supplied with a power cable with or without a wall socket plug. Appliances with plugs must only be connected to sockets that have earth wires correctly installed. Provide an omnipolar cut-off switch with a minimum contact opening of 3 mm (except for plug connections, if the user has access to it). This appliance is type “Y”: the supply cable can only be changed by the Technical Assistance Service and not the user. The cable type and minimum cross-section must be respected. Changing the gas type If the country's regulations allow, this appliance can be adapted to other types of gas (see specifications plate). The components required for this are in the transformation kit supplied (depending on the model) or are available from our Technical Assistance Service. [. . . ] Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Never remove the valve reinforcing ring. Adjust the minimum ring setting by turning the by-pass screw using a flat head screwdriver. Depending on the gas to which your appliance is going to be adapted, see table III, carry out the corresponding action: A: firmly tighten the by-pass screws. [. . . ]