User manual HASBRO PLAY-DOH HAIRDO DOLLY

[. . . ] J If an oven is not installed under the hob, a strip of wood should be fitted, allowing a gap of at least 10 mm from the lowest point on the hob. J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. [. . . ] Preparing the kitchen unit - Figure 1 (depending on models A or B) J The worktop should be flat and horizontal. The cuts should be made in the kitchen unit before installing the hob. Remove any shavings, as these can affect the operation of the electrical components. When the cuts have been made, the unit's stability should be checked again. J The built-in kitchen units must withstand temperatures of up to 90ºC. J A gap of at least 70 mm must be allowed between the hob and the side wall, where applicable. It is not recommended that the hob be placed between two side walls but, if this is the case, a gap of at least 200 mm should be left on one side and a gap of 70 mm on the other. J On appliances with mains connection cable: Connect the connectors of the mains connection cable according to the colour code: Green and yellow Protective conductor $ Blue Neutral (neutral conductor) Brown Live (external conductor). J The green and yellow wire, used as the earth wire, must be connected first and must be longer than the other wires so that, in the event that the hob is moved, the rest of the wires will be disconnected before the earth wire. J Ensure that the wires do not get caught when fitting the hob and keep them away from sharp edges. J The hob and the worktop should not be sealed with silicone, as the hob itself has a seal which serves this purpose. J If an oven is fitted below the hob, feed the hob cable around the left-hand corner to the supply socket, i. The cable should be fed around the side of the hob and not over the top. kochfeld einbauen und anschließen Ć Abbildung 2 J Für die elektrische Spannung siehe Typenschild. [. . . ] kochfeld einbauen und anschließen Ć Abbildung 2 J Für die elektrische Spannung siehe Typenschild. Note For tiled work surfaces, the joints where the tiles meet must be hermetically sealed with silicone rubber. [. . . ]