User manual HASBRO PLAY-DOH PHO-DOH CAMERA

[. . . ] The manufacturer accepts no responsibility for any malfunction or damage which is caused by incorrect electrical installation. j The fuse on devices B or C is essential. J If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated in the fixed installation, in accordance with the installation regulations. [. . . ] J Induction hobs should only be installed on forced ventilation ovens of the same specification. Refrigerators, dishwashers, unventilated ovens or washing machines must not be installed under the hob. J If the hob is installed above a drawer, it is recommended to use an intermediate support, as metal objects stored in the drawer could reach high temperatures as a result of the circulating air coming from the hob's ventilation system. J If you have a mixed model hob (with hotplates based both on radiation and induction) an intermediate support must be fitted if metal parts, which could reach high temperatures, are still accessible below the hob after assembly. The reference code for this accessory is: - 680502 for appliances with induction hotplates. J Any change to the appliance's interior, including changing the power cable, must be performed by the Technical Assistance Service. Ensure this is the case, the dimensions of the panel must be adjusted to fit the measurements of the kitchen unit housing in which the hob will be installed. Fitting the securing rails Ć Figure 5 Notes: Use the lower bolt holes on tiled work surfaces. J If a wooden panel is installed as an intermediate support, this should be 5 mm thick. The following requirements must be observed: - allow a gap of 65 mm between the wooden panel and the top section of the hob. - on models with induction hotplates, an aperture must be cut in the back of the panel (figure 2 A); the aperture must be sufficiently deep to enable the hob cable to be fed through it (figure 3 A). - on mixed models, an aperture must be cut in the left-hand side of the panel (figure 2 B); the aperture must be sufficiently deep to enable the hob cable to be fed through it (figure 3 B). The wooden panel must be as airtight as possible, to separate the drawer from the area in which the hob air is circulated. To Installing and connecting the hob Ć Figure 6 J See the rating plate for the voltage. J Connect according to the connection diagram only. J The earth wire (green and yellow) should be connected first and disconnected last. [. . . ] J The earth wire (green and yellow) should be connected first and disconnected last. It should also be longer than the others, so that even if the hob is moving the other wires can be disconnected before the earth wire. J Do not trap the lead during installation and do not guide it over sharp edges. [. . . ]