User manual HASBRO PLAYSKOOL CLIPO GUIDE

[. . . ] Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions; 2. Do not mix old and new batteries or alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries; 3. [. . . ] DO NOT RECHARGE OTHER TYPES OF BATTERIES. NOTE: Adult should remove and discard rope handle and keep CLIPOTM piece. NOT INCLUDED Phillips/cross head screwdriver (not included) needed to insert batteries. ALKALINE BATTERIES REQUIRED x2 LR6 size 1. 5V AA or clipoTM creativity table TO ASSEMBLE 1. To insure proper, one-time assembly: Place storage buckets on a flat surface (such as the floor). Press down on base on one side and carefully use body weight from above to apply pressure straight down until you hear an audible snap. Each storage compartment's lid incorporates an activity: one lid is a shape sorter, the other one is a drop slot. NOTE: Check to insure tabs are fully inserted in slots. 3. Snap top two peg plates onto the top, in front and in back. 4. Set the two lids into the recesses over the storage buckets. 5. Drop motorized gear into center, button side up, after installing batteries. 3. 25 CLIPOTM pieces included to create a variety of designs. Table surface acts as a platform to build CLIPOTM creations. Add them on for more CLIPOTM fun. NOTE: When storing toy, turn the ON/OFF switch to OFF to prevent accidental FCC STATEMENT Check to insure tabs are in slots. activation. If batteries begin to lose power, gears will turn at a slower rate and it will be less powerful. For best results, replace batteries when this starts to happen. NOTE: To remove motorized This device complies with part 15 of the FCC Rules. [. . . ] · Press the button on top of the motorized gear to run the motor. This will start the center gear and turn the two outside turntables. [. . . ]