User manual HASBRO PLAYSKOOL DREAM TOWN SWEET LILY CASTLE

[. . . ] The application of any foreign substance to the Castle fabric may render the ame resistant properties ine ective. For video assembly instructions, please visit www. mysweetlilycastle. com 2 Fabric Castle Covers BACK FRON T Includes: Also includes: 1 princess dress (fits sizes 3T to 6X) 1 tiara 1 wand 1 frog prince 4x Grey Plastic Tubes 2 x Grey Plastic Connectors 1x Green Plastic Tube 41x Connectors 4 x front bottom connectors (red) 4 x back corner connectors (red) 11 x straight connectors (white) 6 x tee connectors (yellow) 4 x hip corner top connectors (blue) 4 x hip corner base connectors (blue) 4 x roof corner X connectors (green) 4 x roof corner Y connectors (orange) 30x White Frame Tubes 2 x #1 2 x #2 2 x #3 12 x #4 2 x #5 2 x #6 2 x #7 2 x #8 2 x #9 2 x #10 Front side 26x Pink Frame Tubes 2 x #1 2 x #2 10 x #3 2 x #4 2 x #5 2 x #6 2 x #7 2 x #8 2 x #9 Back side 1 Assemble Front frame as shown. This will be done in Three steps: Front Frame Assembly: Parts required for this step: - All connectors - All white frame tubes 1. Start with the base--just like building a normal house. #3 #2 #1 #2 #1 2. [. . . ] The zipper strip should align with the frame. 5 9. Zip up the cover around the frame. Press the three hook-and-loop fasteners along inside the cover at the top of the frame to keep the roof from sagging. 10. Align and fasten the hook-and-loop fastener around both windows. The back of the castle is now complete. Let's do the front! 6 SWEET LILY Castle Front Cover Castle Front Cover: Parts required for this step: - Completed Frame (white) 1. 3. Assemble white frame as shown on page 2. Remove the SWEET LILY Castle front cover from the bag marked "Front". Completely unzip the cover all the way around. 4. Unzip the front doors. 6. Lay the cover so the rectangular red seam - SWEET LILY Castle Front 5. FRON T Separate the inside and outside walls by pulling apart the hook-and-loop fasteners. is exposed. The pink inside wall is over the the printed floor. The doors should be tucked under the floor. 7 6. Line up the frame on the red seam, as shown. 7. Lift the inside wall up and attach it to the frame with the hook-and-loop fasteners. Make sure the bottoms of the strips line up with the bottoms of the pads. 16x fasteners 8 8. Pull out any excess cover from the outside corners of the frame base to make a snug pocket. Pull the cover with the doors over the closed end of the frame and across the roof (you may need a helper). [. . . ] Fit the bottom of the plastic tube into the middle of the center disk in the tower floor. Storage: 3. Reclose the tower and attach it to the hook-and-loop fasteners at the front corners of the castle. [. . . ]