User manual HASBRO POKEMON LIGHTED KEYCHAIN JIGGLYPUFF

[. . . ] The clothes tend to stick. Temperature control (I) setting is too high. Temperature control (I) setting is too low. Steam regulator (A) is set too high in conjunction with a low temperature. Turn the steam regulator to a lower setting. Wait 5 seconds between each press of the shot of steam button. [. . . ] • The iron should not be used if it has been dropped, if there are visible signs of damage or if it is leaking water. It must be checked by an authorized Technical Service Centre before it can be used again. • Do not allow the power cable to come into contact with the soleplate when it is hot. • In order to avoid that, under unfavourable mains conditions, phenomena like transient voltage drops or lighting fluctuations can happen, it is recommended that the iron is connected to a power supply system with a maximum impedance of 0. 27Ω . If necessary, the user can ask the public power supply company for the system impedance at the interface point. • This appliance is not intended to be used by persons (including children) with reduced physical, sensory or mental capacities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. • Keep the appliance out of children’s reach. • Children should be supervised to ensure that they do not play with the appliance. • Remove the plug from the socket before filling the appliance with water or before pouring out the remaining water after use. • The appliance must never be placed directly under the tap to fill the water tank. • The appliance must be used and placed on a stable surface. 3. For silk, woollen or synthetic materials iron the reverse side of the fabric to prevent shiny patches. Avoid using the spray function to prevent stains. 4. Sort your garments based on their care labels, always starting with those that have to be ironed at the lowest temperature. 5. The pilot light on the top of the handle (K) will stay lit while the iron is heating up and go out once the selected temperature has been reached. Wait for a few seconds after the light goes out before you start ironing. Once the iron is ready, you can continue to iron even if the pilot lamp comes on again. 6. If your iron has auto shut-off and the pilot light is flashing, the auto-shut off has activated. Gently move the iron from side to side to restart it. Use only clean water from the tap and do not mix anything with it. The addition of other liquids, such as perfume, will damage the appliance. DO NOT use condensation water from tumble dryers, air conditioners or similar appliances. [. . . ] 4. Set the iron aside in a vertical position to cool down. 5. Coil the power cable (J) loosely around the heel of the iron before storing. 6. Store the iron in an upright position. Multiple de-scaling system This range of irons is equipped with the following descaling features “AntiCalc”. [. . . ]