User manual HASBRO POKEMON THINKCHIP COMPUTERIZED BATTLE STADIUM JOHTO LEAGUE

[. . . ] This rule does not apply to the use of cooking appliances, such as hobs and ovens. Unrestricted operation is possible if the extractor hood is used in recirculating mode ­ with activated carbon filter. filter screen lighting/fan switches alighting door Operating modes Circulating-air mode: Exhaust-air mode: The extractor-hood fan extracts the kitchen vapours and conveys them through the grease filter into the atmosphere. The grease filter absorbs the solid particles in the kitchen vapours. The kitchen is kept almost free of grease and odours. [. . . ] Position the filter screen against the housing and push upwards. Push in the lower edge over the lugs and lower the grid into place. 3. Fleece grease filter Remove saturated filter mat, clean the filter grid and insert new filter mat. Metal grease filter Remove saturated filter mats, clean mats and grid. Refit the cleaned filter mats, making sure that there is no gap in the middle. 2. Check that the filter screen is securely located behind the retaining brackets on both sides. 7 Filters and maintenance Activated carbon filter: For binding odours in recirculating air mode. Push the filter screen up slightly, lift it towards you over the brackets and take it out downwards. Insert activated carbon filter in the lower left corner of the housing. Shift it until both hooks slot into the holes and then secure in place with the wing nut. 2. 3. Insert the screw through the wing nut and bushing and screw into the housing (only necessary upon initial fitting. The screw and wing nut are included with activated carbon filter. Position the filter screen against the housing and push upwards. Do not use abrasive agents. Enter these numbers in the spaces above. You will find the numbers on the rating plate inside the extractor hood after removing the filter screen. 9 Installation instructions Important information Old appliances are not worthless rubbish. Valuable raw materials can be reclaimed by recycling old appliances. Before disposing of your old appliance, render it unusable. You received your new appliance in a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environment by disposing of packaging materials in an environmentally-friendly manner. Please ask your dealer or inquire at your local authority about current means of disposal. The extractor hood can be used in exhaust air or circulating air mode. Always mount the extractor hood over the centre of the hob. The minimum distance between the hob and the lower edge of the extractor hood is 650 mm. [. . . ] (See Filters and maintenance). The extractor hood is designed for installation between two wall cabinets. Remove grease filter (see Filters and maintenance) 2. Using the enclosed template mark the positions of the screws on the side panels of the neighbouring cabinets. 20 34 34 20 Electrical specifications: These can be found on the rating plate inside the appliance following removal of the filter frames. Before carrying out repairs, always isolate the appliance. 13 Installation The extractor hood can also be installed slightly lower, depending on the height of the wall cupboards. Position the template correspondingly lower. [. . . ]