User manual HASBRO POKEMON TOTODILE WITH WATER SQUIRTING ACTION

[. . . ] Young children should be supervised to ensure they do not play with the appliance. The appliance should only be connected up to the mains and taken into use by a qualified specialist. ṇ Dispose of packaging materials properly (see Installation instructions). Defective bulbs should be replaced immediately to prevent the remaining bulbs from overloading. [. . . ]  If the filter mat is going to be cleaned by hand, soak it first of all in a hot detergent solution for several hours. Clean the filter with a brush, rinse it off thoroughly and allow it to drip dry. ❑ Use only original replacement filters. In so doing you will be ensuring that the extractor hood performs as effectively as possible. Press the retaining spring and remove the filter frame. Remove the wire grille and replace the filter mat. Removing and installing the grease filter Extractor hoods with a filter mat: 1. Rotate the handles on the left and right of the filter grille. The left and right sides of the filter frame must lock into position!2005 10:08 Uhr Seite 19 Filters and maintenance Extractor hoods with two filter cartridges: Warning: The halogen bulbs must be switched off and cool. Depress the detent on the grease filters in the direction of the arrow and fold down the grease filter slightly.  Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. Switch off the extractor hood and isolate by pulling out the mains plug or switching off the disconnector on the installation side. When switched on, the halogen bulbs become very hot. Even for some time after the bulbs have been switched off there is still a risk of burns. Remove the bulb ring with a screwdriver or similar tool. Replace the halogen light bulb (conventional halogen bulb, 12 Volt, max. Take hold of the bulb with a clean cloth. If you encounter a problem If you have any questions or if a fault occurs, please call Customer Service. (See list of Customer Service representatives). When you call, please quote the following: E-Nr. [. . . ] Local authority regulations must be observed when discharging air into smoke or exhaust flues that are not otherwise in use. D When the extractor hood is operated in exhaust-air mode simultaneously with a different burner which also makes use of the same chimney (such as gas, oil or coal-fired heaters, continuous-flow heaters, hot-water boilers) care must be taken to ensure that there is an adequate supply of fresh air which will be needed by the burner for combustion. Safe operation is possible provided that the underpressure in the room where the burner is installed does not exceed 4 Pa (0. This can be achieved if the combustion air can be replenished by being able to flow through non-closeable openings such as in doors, windows, wall ventilation boxes, or by alternative technical measures such as reciprocally shutting the other device off, etc. [. . . ]