User manual HASBRO POOH HONEY POT HOP

[. . . ] If this is the case, it should not be removed under any circumstances, since the adhesive seal prevents leaks. If the seal has not been factory-fitted, apply it to the underside of the hob. Fitting the appliance onto the kitchen unit: 1. Remove the clips from the accessory bag and screw them into the position indicated so that they can turn freely. [. . . ] The position of the clips depends on how thick the work surface is. Unscrew the clips and proceed in the reverse order to installation. En I ns tallation instructions Safety precautions Read the appliance instructions before installing and using. The graphics in these Assembly instructions are given as a guide only. The manufacturer is exempt from all liability if this manual's requirements are not complied with. All operations relating to installation, regulation and conversion to other gas types must be carried out by an authorised installation engineer, respecting all applicable regulations, standards and the specifications of the local gas and electricity providers. You are recommended to contact the Technical Assistance Service to convert to another gas type. Before you begin, turn off the appliance's electricity and gas supply. This appliance has been designed for home use only, not for commercial or professional use. This appliance cannot be installed on yachts or in caravans. The warranty will only be valid if the appliance is used for the purpose for which it was designed. This appliance is type “Y”: the supply cable can only be changed by the Technical Assistance Service and not the user. The cable type and minimum cross-section must be respected. Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. Changing the gas type If the country's regulations allow, this appliance can be adapted to other types of gas (see specifications plate). The components required for this are in the transformation kit supplied (depending on the model) or are available from our Technical Assistance Service. The following steps should be taken: A) Changing the nozzles (fig. Change the nozzles using the spanner provided by our Technical Assistance Service (code 340847 or 340808 for double-flame burners), see table II, taking special care to ensure that the nozzle does not fall when it is removed from or fitted to the burner. Ensure that it is completely tightened in order to guarantee the seal. Primary air adjustment is not necessary with these burners. Position the diffusers and burner caps on the corresponding rings. The pan supports must also be positioned correctly. [. . . ] Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Never remove the valve reinforcing ring. Adjust the minimum ring setting by turning the by-pass screw using a flat head screwdriver. Depending on the gas to which your appliance is going to be adapted, see table III, carry out the corresponding action: A: firmly tighten the by-pass screws. [. . . ]