User manual HASBRO POPEYE ATARI 5200

[. . . ] Appliances with electrical supply must be earthed. Do not tamper with the appliance's interior. If necessary, call our Technical Assistance Service. Before installing This appliance is class 3 type, according to the EN 30-1-1 regulation for gas appliances: built-in appliance. [. . . ] The laminated covering and glue for adhering it must be heat resistant. This appliance cannot be installed above fridges, washing machines, dishwashers or similar. An oven must have forced ventilation to install a hob above it. Check the dimensions of the oven in the installation manual. If an extractor fan is installed, you must follow the installation manual's instructions, always keeping a minimum distance of 650 mm to the hob. 7-7a): 340808 for double-flame burners or triple-flame burners) provided by our Technical Assistance Service, see table II, taking special care to ensure that the nozzle does not fall when it is removed from or fitted to the burner. Ensure that it is completely tightened in order to guarantee the seal. Primary air adjustment is not necessary with these burners. Simply press on this seal with the tip of a screwdriver to allow access to the tap adjusting screw. Never remove the valve reinforcing ring. If the seal has not been factory-fitted, apply it to the underside of the hob. Fitting the appliance onto the kitchen unit: 1. Screw each one of the clips into the position indicated so that they are free to rotate. Press the sides of the hob until it is supported around its entire perimeter. The position of the clips depends on how thick the work surface is. Unscrew the clips and proceed in the reverse order to installation. 5) The end of the inlet connection point of the gas hob has a 1/2” (20. 955 mm) thread that allows for: ■ fixed connection. The watertight seal (034308) supplied must be inserted between the manifold outlet and the gas supply. You must prevent the pipe from coming into contact with moving parts of the kitchen unit (for example, a drawer) and prevent access to any spaces which might become obstructed. [. . . ] If you need to connect the gas supply horizontally, our Technical Assistance Service can supply you with an L-tube (code 173018) and a seal (code 034308). If you need to make a cylindrical connection, replace the factoryfitted L-tube with the one in the accessory bag. If any connection is handled, check the seal. The manufacturer is not liable for any connection leaking, after being handled. [. . . ]