User manual HASBRO PRETTY PRETTY PRINCESS 1990

[. . . ] Indd 1 2011-12-28 4:27:10 safety instructions Throughout this manual, you’ll see Warning and Caution notes. These warnings, cautions, and the important safety instructions that follow do not cover all possible conditions and situations that may occur. It’s your responsibility to use common sense, caution, and care when installing, maintaining, and operating the dishwasher. Samsung is not liable for damages resulting from improper use. [. . . ] The hot water supply line must pass through the channel on the bottom of the dishwasher as shown in Figure 2. Do not place the dishwasher on the water supply line. The drain hose connected to the dishwasher must be run through the hole in the side wall so it can be connected to the drain outlet of the sink. When you install the dishwasher, ensure there is nothing on the drain hose and be careful not to tear it during the installation process. Indd Sec3:9 2011-12-28 4:27:24 installing the dishwasher STEP 4 CHECK THE ELECTRICAL REQUIREMENTS AND CAUTIONS The electrical requirements for the dishwasher are as follows: • In the United States, install in accordance with the National Electric Code/State and Municipal codes and/or local codes. - Use flexible, armored or non-metallic sheathed, copper wire with a grounding wire that meets the wiring requirements for your local codes and ordinances. - Use the strain relief method provided with the wiring junction box or install a U. € For power cord connections - The power supply cord must plug into a mating three prong, grounded outlet, located in the cabinet next to the dishwasher opening. The outlet must meet your local codes and ordinances. The dishwasher must be connected to an electrical supply that provides the voltage and amperage marked on the rating plate of the unit: 15 amps, 120 volts, 60Hz AC. Ensure that the circuit breaker connected to the dishwasher is off. To prevent the inlet valve from being blocked, make sure that the Teflon tape does not enter the valve. Cut the strings securing the drain hose to the back of the dishwasher. Make sure there are no kinks and that the hose is not bent at any extreme angles that could constrict the flow of water. Remove the junction box cover located at the bottom front right of the dishwasher using a screwdriver, and then Install the strain relief (Figure 4 - C). Make sure to keep the junction box cover you removed. If the countertop is made of wood or a material that is not damaged by drilling, attach the two (2) Installation brackets that were supplied with the dishwasher using the supplied screws (Figure 4 - A). They will be used in Step 8, Securing the Dishwasher. <Figure 4> A B C Junction box Strain relief CAUTION Do not overtighten the 90˚ elbow. Doing so may damage the water inlet valve and cause a water leak installing the dishwasher _13 installation_DD68-00046A-05_EN. indd Sec3:13 2011-12-28 4:27:24 installing the dishwasher STEP 7 PLACING THE DISHWASHER AND CONNECTING THE HOT WATER SUPPLY LINE 1. Adjust the three leveling legs at the bottom of the dishwasher after measuring the height of the cabinet opening from under the countertop to the floor. [. . . ] Clean around the sink’s drain connection so that it does not damage the hose. Check for any foreign items in the drain hose and remove them. (25 mm) (19 mm) (13 mm) If required, cut off the end of the drain hose at one of the dotted lines. Before connecting the power cable to the dishwasher, make sure the circuit breaker is off. [. . . ]