User manual HASBRO PUPPY RACERS

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and the receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] €¢ The document will be scanned into memory, and your fax will go on polling standby. Clearing a document To clear a memory poll document from memory, follow the steps below: 1 Press MENU and then 7 . Book Page 74 Tuesday, October 1, 2002 7:03 PM Polling Polling Security Polling Security allows you to prevent unauthorized polling of your fax. When this function is activated, polling will only take place when one of the following conditions is met: ♦ The fax number of the polling fax machine has been stored in your fax’s list of permitted fax numbers (called "passcode numbers"). The polling fax must also have its fax number programmed in itself, as explained in Entering Your Name and Fax Number in Chapter 1. ™¦ A System number has been programmed in the polling fax machine which matches your fax’s System number or one of your ID numbers. ™¦ An ID number has been programmed in the polling fax machine which matches your fax’s System number. System and ID numbers are 4-digit numbers which provide you with an alternate means of giving and receiving polling permission when you don’t want to use fax numbers. The steps for programming these numbers are described in the following pages. Note: System and ID numbers can only be used if the other fax machine is also a Sharp machine. Turning Polling Security on and off Polling Security is turned on or off with Option Setting 8 as explained on page 104. 1 2 3 4 5 Transmission (SEND MODE) Confidential transmission Polling Serial Polling Broadcasting 4 Enter a two-digit number for the hour (“01” to “12”) and a two-digit number for the minute (“00” to “59”). Enter a number as follows to select the day of the operation (skip this step if the operation will be performed within the next 24 hours): 0 1 2 3 4 5 6 Sunday Monday Tuesday Wednesday Thursday Friday Saturday 7 Press START/ ENTER and go to the specific procedure for your operation (see the following pages). transmission (Continued from Initial procedure. ) 8 Dial the receiving machine using one of the following methods: • Press a Rapid Key. €¢ Press SPEED DIAL and enter a Speed Dial number (if you enter less than 2 START/ ENTER digits, press to complete the entry). €¢ Enter a full fax number with the numeric keys. Book Page 79 Tuesday, October 1, 2002 7:03 PM Timer Operations 10 Press RESOLUTION and/or CONTRAST to adjust the resolution and contrast if desired, and then press START/ ENTER . 11 Load the document and then press START/ ENTER . ) 8 9 10 Enter the mailbox number (2 digits). (Go directly to Step 9 if the receiving machine does not have mailboxes. Dial the receiving machine using one of the following methods: • Press a Rapid Key. [. . . ] sARA(Superfund Amendments and Reauthorization Act) Title III 302 Extreme Hazardous Substance: None 311/312 Hazard Categories: None 313 Reportable Ingredients: None California Proposition 65: This product contains no chemical substances subject to California Proposition 65. EU Information Information on the label (88/379/EEC) and 67/548/EEC) : Symbol & Indication : Not required R-phrase : Not required S-phrase : Not required 76/769/EEC: All chemical substances in this product comply with all applicable rules or order under 76/769/EEC. Other Information NFPA Hazard Rating: The National Fire Protection Agency(USA): Health: 1 Flammability: 1 Reactivity: 0 HMIS Rating: The National Paint and Coating Association(USA): Health: 1 Flammability: 1 Reactivity: 0 Recommended Uses: Toner for Electrophotographic Equipment Restrictions: This information relates only to the specific material designated as supplied by the manufacturer. This information is supplied to us by the manufacturer and Sharp offers no warranties as to its accuracy and accepts no responsibilities for any typographical errors which may appear on these sheets. [. . . ]