User manual HASBRO PUZZ 3D MINIATURES IGLOO

[. . . ] CAUTION: The AC outlet shall be installed near the equipment and shall be easily accessible. 1 E IMPORTANT INFORMATION (Continued) WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipment. ONLY CAUTION: Use the supplied power cord as it is. NOTE: This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Use this automatic adjustment when you use the PC2 input terminal or PC3 input terminals to display a PC screen for the first time or when you change the setting of the PC. ) CLOCK Adjusts frequency for sampling clock for applicable video. Adjust when there is flickering in the form of vertical stripes. When using the adjustment pattern (see page 23), make adjustments so that no vertical stripe noise appears in it. pHASE Adjusts sampling clock phase for applicable video. Useful when small characters appear with low contrast and/ or there are flickers at corners. When using the adjustment pattern (see page 23), make adjustments so that no horizontal stripe noise appears in it. * Adjustments to PHASE should be made only after CLOCK has been correctly set. H-POS Adjust the horizontal position of the image. V-POS Adjust the vertical position of the image. RESET Resets the values of the SCREEN menu items to the factory preset values. 768LINES (PC2/PC3) If a computer connected to the PC2/PC3 input terminal has a resolution of 1024 x 768, 1280 x 768 or 1360 x 768, make a selection according to the resolution. SELF ADJUST On a PC2/PC3 screen with a resolution of 800 x 600 or higher, specify whether to perform screen adjustment automatically or not. When ON is selected, the screen is automatically adjusted when the timing of input signals varies. €ADJUSTING” appears on the screen during the adjustment. POWER MANAGEMENT POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal standby mode when the PC screen is displayed. ENGLISH PATTERN 3 PATTERN 4 MOTION TIME 1 Specify a time period (operating interval) until SCREEN MOTION starts. MOTION TIME 2 Specify a time period during which SCREEN MOTION operates (time period during which the screen will move). LANGUAGE Sets the display language for the menu screen. SET Assigns ID numbers to monitors connected in a daisy chain (see page 26), using RS-232C cables. The numbers 1 to 255 are available for ID numbers. If “0” is set, the system regards this as the state where no ID number is set. [. . . ] Internal temperature rises quickly if the vents on the monitor are blocked. € Internal temperature rises quickly if dust accumulates inside the monitor or around the vents. Ask Sharp dealer about removing internal dust. 3 (65) (excluding the temporary stand) *1 *2 *3 Cannot be used simultaneously. [. . . ]