User manual HASBRO PUZZ 3D MINIATURES NEW YORK TAXI CAB

[. . . ] € The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. ensure that your equipment is connected correctly. If you are in any doubt consult a qualified electrician. “WARNING: THIS APPARATUS MUST BE EARTHED. [. . . ] - Install the monitor such that the power LED is located on  the downside. - Set the MONITOR on the SETUP menu to PORTRAIT. ) • Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction. € After mounting, it is recommended to take some measures to prevent the monitor from falling down. € Do not place the monitor on a device which generates heat. € Use the supplied vertical logo sticker when you install the monitor in vertical orientation. ENGLISH * INPUT * 2 [5] 2 [5] 2 [5] For the monitor in vertical orientation Unit: inch [cm] 7-7/8 [20] * * Do not remove the factory-affixed sticker but affix the logo sticker over it. Be careful not to cover the remote control sensor or buttons. € Be sure to use a stand or a wall-mount/ceiling bracket designed or designated for mounting the monitor. • This monitor is designed to be installed on a concrete wall/ ceiling or pillar. Set DVI SELECT of INPUT SELECT on the OPTION menu to AV1 DVI-D when using the AV1 input terminal. ) • Use a commercially available HDMI cable (conforming to the HDMI standard) for the AV2 input terminal. Set HDMI SELECT of INPUT SELECT on the OPTION menu to AV2 HDMI when using the AV2 input terminal. In addition, select the audio input terminal to be used in HDMI AUDIO SELECT of INPUT SELECT on the OPTION menu. Set BNC SELECT of INPUT SELECT on the OPTION menu to AV3 COMPONENT when using the AV3 input terminals. € The AV1/AV2 input terminals are compatible with the video signals below: 1920 x 1080 p @ 50/59. 94/60Hz • The AV3 input terminals are compatible with the video signals below: 1080p @50/60Hz, 1080i @50/60Hz, 720p @50/60Hz, 576p @50Hz, 576i @50Hz, 480p @60Hz, 480i @60Hz 10 Connecting Peripheral Equipment Other terminals PC/AV audio output terminals • Audio from the equipment connected to the AV audio input terminals or PC audio input terminal is output. Connect to the audio input terminals of the connected equipment using a commercially available audio cable (RCA). ) • The volume level can be adjusted using the volume adjustment. ) • Selecting FIXED of “AUDIO OUTPUT” from the OPTION menu fixes the volume of sound output from the audio output terminals. ) • Audio signals output from the PC/AV audio output terminals cannot be adjusted using the AUDIO menu. [. . . ] 0 (39) (excluding the temporary stand) *1 *2 *3 *4 Cannot be used simultaneously. When STANDBY MODE is set to LOW POWER, LAN and SCHEDULE are not used. Colors Pixel pitch Viewing angle Screen active area inch (mm) Computer input signal Sync signal As a part of our policy of continuous improvement, HASBRO reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. [. . . ]