User manual HASBRO PUZZ 3D MINIATURES PEPPERCRICKET FARMS

[. . . ] € The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. ensure that your equipment is connected correctly. If you are in any doubt consult a qualified electrician. “WARNING: THIS APPARATUS MUST BE EARTHED. [. . . ] 5] 115/16 [5] ENGLISH 115/16 [5] 1-15/16 [5] • If it is difficult to provide this much space for any reason such as the installation of the monitor inside a housing, or if the ambient temperature may be outside of the range of 32 °F (0°C) to 104°F (40°C), install a fan in the housing or take other measures to keep the ambient temperature within the required range. € Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a malfunction. € After mounting, it is recommended to take some measures to prevent the monitor from falling down. Secure the monitor by fastening the hooks at the top of the monitor to a wall or a pillar with strong cord and brackets (not included). € Do not place the monitor on a device which generates heat. € This monitor is fixed to the temporary stand when shipped from the factory. Please note that this stand is for temporary use only until the monitor is properly mounted. € Be sure to use a stand or a wall-mount bracket designed or designated for mounting the monitor. • This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary for some materials such as plaster / thin plastic board / wood before starting installation. Set BNC SELECT of INPUT SELECT on the OPTION menu to AV3 COMPONENT when using the AV3 input terminals. € The AV1/AV2 input terminals are compatible with the video signals below: 1920 x 1080 p @ 50/59. 94/60Hz • The AV3 input terminals are compatible with the video signals below: 1080p @50/60Hz, 1080i @50/60Hz, 720p @50/60Hz, 576p @50Hz, 576i @50Hz, 480p @60Hz, 480i @60Hz 10 Connecting Peripheral Equipment Other terminals PC/AV audio output terminals • Audio from the equipment connected to the AV audio input terminals or PC audio input terminal is output. Connect to the audio input terminals of the connected equipment using a commercially available audio cable (RCA). ) • The volume level can be adjusted using the volume adjustment. ) • Selecting FIXED of “AUDIO OUTPUT” from the OPTION menu fixes the volume of sound output from the audio output terminals. ) • Audio signals output from the PC/AV audio output terminals cannot be adjusted using the AUDIO menu. PC/AV output terminals Video signals from PC1 and AV1 can be output to external device. Use this terminal when you connect multiple monitors in a daisy chain via DVI cable (commercially available). ) Outputting images encoded with HDCP requires an HDCPcompatible external device. Images cannot be output in the following situations: - In PC2/AV2 input mode -  hen PIP SOURCE in the PIP/PbyP Menu is set to PC2 W HDMI or AV2 HDMI RS-232C input/output terminals You can control the monitor from a PC by connecting a commercially available RS-232 straight cable between this terminal and the PC. [. . . ] Ask Sharp dealer about removing internal dust. 7 (62) (excluding the temporary stand) *1 *2 *3 *4 Cannot be used simultaneously. When STANDBY MODE is set to LOW POWER, LAN and SCHEDULE are not used. Colors Pixel pitch Viewing angle Screen active area inch (mm) Computer input signal Sync signal As a part of our policy of continuous improvement, HASBRO reserves the right to make design and specification changes for product improvement without prior notice. [. . . ]