User manual HASBRO PUZZ 3D TITANIC

[. . . ] This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. CAUTION The AC outlet shall be installed near the equipment and shall be easily accessible. FOR YOUR RECORDS Please record below the model number and serial number, for easy reference, in case of loss or theft. [. . . ] For example, when the time is set to 2:30 AM, enter 230; and when it is set to 2:30 PM, enter 1430. The time is printed and displayed on the real time system. 22 0:18 PM Page 82 2 Setting the register and consecutive numbers Setting the register number PGM 2 2612 When your store has two or more registers, it is practical to set separate register numbers for their identification. You may set them with a maximum of six digits. Procedure To set the register number “0” 2612 . @ Register number (one to six digits) Ç Print Example To set the register number as “123456” Key operation 2612 . @ 123456 Ç Register number Setting the consecutive number PGM 2 2613 The consecutive number is increased by one each time a receipt is issued. Enter a number (one to four digits) that is one less than the desired starting number. Procedure To begin the count from 0001 2613 . @ A number (one to four digits) that is one less than the desired starting number Ç Print Example Setting the count start number as “1001” Key operation 2613 . 22 0:18 PM Page 83 3 Programming for the automatic tax calculation function Your machine has an automatic tax calculation feature which allows you to program four tax tables or rates to avoid calculating incorrect tax amounts. @ 1@ Tax rate ¡ 6@ M ¡ 100 @ T ¡ 1@ Q ¡ 11 @ 23 @ The first 39 @ cyclic 57 @ portion 73 @ 89 @ M1 (MAX point)¡ 111 @ a Note You do not need to enter the trailing zeros of the tax rate (after the decimal point) but you do need to enter the decimal point for fractions. 22 0:18 PM Page 85 • If the tax is not provided for every cent, modify the tax table by setting the tax for every cent in the following way. When setting the tax, consider the minimum breakpoint corresponding to unprovided tax to be the same as the one corresponding to the tax provided on a large amount. ) *A: When you program a tax rate as tax rate 1, enter “1”; when you program it as tax rate 2, enter “2”; when you program it as tax rate 3, enter “3”; and when you program it as tax rate 4, enter “4”. 22 0:18 PM Page 86 Example Programming the tax rate 4% as tax rate 2 with tax exempt as 12¢ Key operation Print 2711 . @ 2@ 4@ 12 a Note • If you make an incorrect entry before pressing the third @ key in programming a tax rate, cancel it with the c key; and if you make an error after pressing the third @ key, cancel it with the ı key. Then program again from the beginning correctly. € You do not need to enter the trailing zeros of the tax rate (after the decimal point), but you do need to enter the decimal for fractions. Doughnut tax exempt (for the Canadian tax system) Procedure To program zero Q’ty for doughnut tax exempt (max. 2 digits: 1 to 99) PGM 2 2715 2715 . @ a Note This option is available only when your register has been set up with the Canadian tax system. [. . . ] • Is a cashier code assigned to the register?€ Is the mode switch set properly at the “REG” position?€ Is the receipt paper roll properly installed?€ Is the receipt function in the “OFF” status? [. . . ]