User manual HASBRO Q-BERT QUBESATARI2600

[. . . ] Unplug from outlet when not in use and before user-servicing. Close supervision is necessary when used by or near children. Do not allow this vacuum to be used as a toy. use only manufacturers recommended attachments. [. . . ] Medium power levels are positioned between "H" and "L". 13) Combine these wands at the end of suction hose. 14-1) When connecting two wands, match the illustrated mark to each other. 14-2) SUCTION HOSE For using ON BOARD tools, remove the suction hose from the nozzle head. 11) UPHOLSTERY TOOL WITH DETACHABLE BRUSH Use the brush for upholstered furniture, table tops, books, lamps, baseboards, etc. 16) Use without the brush for draperies, mattresses, clothing, carpeted stairs, etc. 16 HEAT PROTECTION SYSTEM This vacuum cleaner has a special thermostat that protects the motor from overheating. If the vacuum cleaner suddenly shuts off, turn off the vacuum and unplug the cleaner. Check the vacuum cleaner for a possible source of overheating such as a full dirt compartment or clogged filters. If these conditions are found, empty the dirt compartment and clean the filters (see pages 10 and 11) or replace if necessary (see page 15). To maintain the best performance of your vacuum cleaner, we recommend emptying the dirt compartment before the dirt reaches the “Max Fill Line” and clean the filters. 26 CAUTION: Do not use a washing machine for cleaning. Be sure the filter is set in the right position. NOTE: For maximum performance we recommend to clean this filter every time you empty the dirt compartment. 20, 8:07 AM WHEN YOU FOUND ANY OBSTACLES IN THE HEAD COVER OR FRONT CHANNEL If you find some obstacles such as hair, paper slip, are caught inside the head cover or front channel, please try to remove with suction hose of this vacuum cleaner. 27) If this is not enough cleaning, please use some wooden stick for picking, or removing bottom plate and / or head cover for cleaning. net Filter Suction Hose Front channel Fig. 27 HOW TO REMOVE / AND RESET THE BOTTOM PLATE Before replacing any parts, unplug the vacuum cleaner from the electrical outlet and release the handle. Then turn the vacuum cleaner over, exposing the underside. four Screws REMOVE Loosen the bottom plate by unscrewing four screws , (Fig. 28 RESET Make sure that all the parts are properly position. The bottom plate 1 Insert the front three tabs ofend of the nozzle into the grooves at the front head, then reset the bottom plate. [. . . ] Suction power is weak or decreases suddenly. Check Check if the power cord plug is completely inserted into the outlet. Be sure the flat belt is not severed or installed incorrectly. be sure the "RUG/FLOOR" pedal is in "Rug". [. . . ]