User manual HASBRO RISK LORD OF THE RINGS TRILOGY EDITION

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following: • • • • Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. [. . . ] This will help to ensure that the imaging process is successful. The following chart may be useful as a guide: SSD capacity 32GB 40GB 64GB 80GB 128GB 160GB 256GB 512GB Adjusted HDD Used Space 27GB or less 34GB or less 54GB or less 66GB or less 109GB or less 136GB or less 218GB or less 423GB or less Adjusted HDD Used space = SSD capacity X 85% After the cloning process has been successfully completed, these files can be moved back to their original location on the hard drive. Handling Precautions To prevent damage from static electricity, observe the following precautions: ● Allow the drive to remain in the anti-static container until you are ready to install the SSD. — Wear a wrist strap and connect the ground strap to the computer case to minimize static electricity. Turn off the power to your computer and disconnect the power source. Remove the system chassis cover according to the system manufacturer’s instructions. 5” mounting brackets (provided) to the SSD by aligning the mounting screw holes on the brackets with those on the SSD and inserting the M3 flat head screws provided. 5 inch drive bay inside your computer and install the SSD using the 6/32” pan head screws (provided). Note: Your system may require proprietary chassis screws, rails or a bracket system to be used with its drive bay(s). If this is the case, please attach that hardware to the 2. 5” mounting bracket for compatibility with your computer chassis. Ensure that the SATA data and power cables are connected to the drives and motherboard. If all connections are in place, it is possible that your system 9 SSDNow For Desktops BIOS does not have the spare SATA ports turned on or enabled. If this is the case do the following: 1) Restart your computer. While the system is restarting, activate the system setup program (BIOS) by repeatedly pressing a special key such as ESC, F1, F12 or DELETE. (Consult your computer system’s documentation for the correct key. ) 2) While in the system BIOS, look for an entry labeled "Drives or Hard Drives. " Select this field using the arrow keys on your keyboard and press Enter. Here, the spare SATA ports can be enabled or turned on by selecting the SATA port and changing the value to "On" or "Enabled". For best results, it is recommended that you enable or turn on all SATA ports during this process. 3) Exit the BIOS by pressing the ESC key. 4) Restart the computer, booting to the software CD, and try the cloning process again. [. . . ] (Consult your computer system’s documentation for the correct key. While in the BIOS, change the "Hard Drive Boot Priority" so that the disk labeled "SSDxxxx" is in the first position. When the computer restarts, it should now boot to your new SSD drive. Note: Your original system hard drive can now be used as a secondary data disk for data storage and should be viewable via My Computer (Computer in Vista). [. . . ]