User manual HASBRO ROBIN HOOD

[. . . ] 38 Faults in the water intake/water drain . 39 General problems with the dishwasher . 49 Cleaning the drain pump and non-return valve . 58 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. [. . . ] If refill salt and/or rinse aid or a fault are present in the display, the dishwasher will not switch to Standby mode. Selecting a program Choose your program according to the type of load and soiling. See the "Program Guide" for more information. ^ Select the desired program with the Program selection button. The indicator light for the selected program will come on. You can now select any additional options (see "Additional Options"). 32 Use Program guide When to use Pre-rinse 1 2 Program sequence Main Interim rinse Final Drying wash rinse 1 2 X X X X Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended Program for completely washing a full load of normally soiled dishware with the ability to adjust energy and water consumption based on the soil load of the dishware. For temperature sensitive glassware and lightly soiled dishware, use 50% detergent recommended. baby bottles, cutting boards and preparation dishware. "Quick program" for lightly soiled dishware, e. g. party dishware or to remove salt traces from the wash cabinet after refilling salt, not suitable for detergent tabs. To rinse dishes when a complete program is not needed. X Normal as required X X X X China & Crystal X X X X X SaniWash X X X X Express X X X X Rinse & Hold X Usage: Electrical - 0. 01 - 1. 23 kWh Water - 1. 3 - 6. 3 gal (5 - 24 l) 33 Use At the end of a program ^ Open the door slightly to check whether the program has finished. The indicator for the selected program has gone out. ^ Turn the dishwasher off with the V button. ^ Press and hold the Program button and turn the dishwasher on simultaneously using the K button. Keep the program button pressed for at least four seconds until the lower right program indicator lights up. ^ Press the Program button four times briefly. The "Intake/Drain indicator flashes 4 times at short intervals. The sequence of flashing by the upper right program indicator shows whether the program end buzzer is turned on or off: ­ upper right program indicator flashing: buzzer is turned on ­ upper right program indicator is off: buzzer is turned off ^ To change the setting press the "Program" button (for at least one second) until the "Intake/Drain" indicator lights up. ^ Turn the dishwasher off with the V button. 36 Additional options Factory default All settings can be reset to factory default. ^ Turn the dishwasher off with the V button. ^ Press and hold the Program button and turn the dishwasher on simultaneously using the K button. Keep the Program button pressed for at least four seconds until the lower right program indicator lights up. ^ Press the Program button briefly 12 times. [. . . ] ­ If the water pressure if lower, a "Water Intake" notification will be shown. See "Frequently Asked Questions" for more information. ­ If the water pressure is higher than shown, a pressure reducing valve must be used. Ensure that the water connection is secure after the first use. , Installation, repairs and other dishwasher! , Do not drink water from the ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]