User manual HASBRO ROBOCOP AND THE ULTRA POLICE 1989

[. . . ] 43 General problems with the dishwasher . 53 Cleaning the drain pump and non-return valve . 62 3 IMPORTANT SAFETY INSTRUCTIONS WARNING ­ When using your dishwasher, follow basic precautions, including the following: Electrical Safety ~ Before installation, make sure that Read all instructions before installation or use of the dishwasher to prevent injury and machine damage. Use the dishwasher only for its intended purpose. [. . . ] The indicators and time display (where appropriate) can be turned off and only the Start/Stop indicator light flashes slowly. ^ To turn the dishwasher back on press K. If you do not turn the dishwasher off after the program ends, it will turn completely off after a few minutes in standby mode (see "Settings - Optimize standby"). If refill salt and/or rinse aid or a fault are present in the display, the dishwasher will not go into Standby mode. At the end of a program At the end of a program the display shows End. The drying fan will continue to run for a few minutes at the end of the "Express" program. You can now open the dishwasher and remove the dishes. , To avoid damage to counter tops rom steam, open the door after the end of the program either fully (never ajar) or keep it closed until you are removing all the dishes. Turning off At the end of a program: ^ Press the K button to turn the dishwasher off. The dishwasher continues to use electricity until turned off with the K button. The refill messages can be turned off when you use a tab detergent (see "Before using for the first time"). Fault messages cannot be turned off. Preparing your appliance for an extended vacation If you elect to turn off the water to your home for an extended period of time, please note that this may not be enough to reduce the risk of a leak. To be completely safe, you must turn off the water supply to each individual appliance. This means under the sink for a dishwasher, at the laundry bib for your washer, etc. 36 Use Unloading the dishwasher Dishes tend to break and chip more easily when they are hot. Allow the dishes to cool until they are comfortable enough to handle before unloading them. ^ Select the desired program with the "Program" button. ^ Press the "Delay start" button. The last delay start time will show in the time display. ^ Set the desired delay start time with the "Delay start" button. If you press and hold the "Delay start" button, the time will automatically count up to 24^. To start again at 0. 5 minutes, press the "Delay start" button twice. The "Start/Stop" indicator light comes on. The time will count down to the program start: in 1-hour increments over 10 hours, in 30-minute (. 5 hr) increments under 10 hours. Once the delay start time has elapsed, the selected program starts. The time display goes out and the "Start/Stop" indicator light comes on. Delay start display: Between 1 hour and 9. 5: e. [. . . ] ­ If the water pressure if lower, a "Water Intake" notification will be shown. See "Frequently Asked Questions" for more information. ­ If the water pressure is higher than shown, a pressure reducing valve must be used. Ensure that the water connection is secure after the first use. , Installation, repairs and other dishwasher! , Do not drink water from the ­ The dishwasher can heat its own water to the temperature required by the wash program. [. . . ]