User manual HASBRO RUGRATS 600-005

[. . . ] Make sure that the instructions are kept with the appliance if it is sold, given away or moved.  The appliance must be installed by a qualified professional according to the instructions provided.  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanentlyventilated rooms, in accordance with current national legislation. [. . . ] If the appliance is fitted with an electronic lighting device* (see figure), press the BURNER knob and turn it in an anticlockwise direction, towards the minimum flame setting, until the burner is lit. The burner may be extinguished when the knob is released. If this occurs, repeat the operation, holding the knob down for a longer period of time.  If the flame is accidentally extinguished, switch off the burner and wait for at least 1 minute before attempting to relight it. If the appliance is equipped with a flame failure safety device*, press and hold the BURNER knob for approximately 2-3 seconds to keep the flame alight and to activate the device. To switch the burner off, turn the knob until it reaches the stop position •. Practical advice on using the burners For the burners to work in the most efficient way possible and to save on the amount of gas consumed, it is recommended that only pans that have a lid and a flat base are used. They should also be suited to the size of the burner: Burner Fast (R) Semi Fast (S) Auxiliary (A) Triple Crown (TC) ø Cookware Diameter (cm) 24 - 26 16 - 20 10 - 14 24 - 26  For models equipped with a reducer grid, the latter must be used only for the auxiliary burner, when pans with a diameter of less than 12 cm are used. Setting the time Press the PROGRAMMER knob and turn it in an anticlockwise direction to set the correct time. 12 9 6 3  The clock can only be set if the oven is connected to the electricity mains. In case of a power failure, the PROGRAMMER will stop: the correct time will need to be reset once the power has returned. 21 GB Planning your cooking Programming cooking time with immediate start 1. Turn the PROGRAMMER knob in an anticlockwise direction until the desired cooking time is displayed. Pull the PROGRAMMER knob and turn it in an anticlockwise direction until the marker corresponds with the current time. A click will indicate the end of the programming phase. Select the desired cooking mode using the SELECTOR knob. The oven switches on immediately and remains on for the entire duration of the set cooking time. When the set time has elapsed, a buzzer will sound. To stop the cooking process, turn the PROGRAMMER knob in an anticlockwise direction until the symbol “'” is displayed. Turn the SELECTOR knob to the “0” position. And a time of 1 hour and 15 minutes is programmed. Turn the PROGRAMMER knob in an anticlockwise direction until the desired cooking time is displayed. [. . . ] • Always keep the oven door closed when using the GRILL and GRATIN modes: This will achieve improved results while saving energy (approximately 10%). • Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 24 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. [. . . ]