User manual HASBRO SEW EASY

[. . . ] Adjacent Room Room to be Vented Enlarging the ventilation slot between window and floor. The system can also provide the air needed for combustion indirectly, i. From adjacent rooms fitted with air circulation tubes as described above. However, these rooms must not be communal rooms, bedrooms or rooms that may present a fire hazard. [. . . ] do not use extension cords or multiple sockets.  Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible.  The cable must not be bent or compressed.  The cable must be checked regularly and replaced by authorised technicians only (see Assistance).  The manufacturer declines any liability should these safety measures not be observed. Connection with a rigid pipe (copper or steel)  Connection to the gas system must be carried out in such a way as not to place any strain of any kind on the appliance. There is an adjustable L-shaped pipe fitting on the appliance supply ramp and this is fitted with a seal in order to prevent leaks. The seal must always be replaced after rotating the pipe fitting (seal provided with appliance). These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed.  Only use pipes and seals that comply with current national regulations. Once the adjustment has been made, replace the seals on the by-passes using sealing wax or a similar substance. 78 MJ/m3 (1) Only for appliances with the security device. S R S A SEW EASY/HA 17 Description of the appliance GB Overall view GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS GAS BURNERS button* SAFETY DEVICES* Ignition for GAS BURNERS* • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with. • Control Knobs for GAS BURNERS adjust the power or the size of the flame. GAS BURNER ignition* enables a specific burner to be lit automatically. • SAFETY DEVICE* stops the gas flow if the flame is accidentally extinguished. 18 Start-up and use The position of the corresponding gas burner or electric hotplate* is shown on every knob. Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: • Off Maximum Minimum To light one of the burners, hold a lit match or lighter near the burner and, at the same time, press down and turn the corresponding knob anti-clockwise to the maximum setting. Since the burner is fitted with a safety device, the knob should be pressed for approximately 6 seconds to allow the automatic device keeping the flame alight to heat up. When using models with an ignition button, light the desired burner by first pressing the gas burners button (identifiable by the symbol), then pressing down the corresponding knob as far as possible and turning it anticlockwise towards the maximum setting. [. . . ] • The appliance must be used by adults only, to cook food according to the instructions in this manual. • Ensure that the power supply cables of other electrical appliances do not come into contact with the hot parts of the hob. • The openings used for ventilation and dispersion of heat must never be covered. • Always make sure the knobs are in the “l”/“¡” position when the appliance is not in use. [. . . ]