User manual HASBRO SHREK 2 CHATEAU DU LOINTAIN ROYAUME

[. . . ] Pass them on to possible new owners of the appliance. The compressor and condenser give off heat and require good ventilation to operate correctly and save energy. Leave a space of at least 10 cm between the top part of the appliance and any furniture above it, and at least 5 cm between the sides and any furniture/side walls. Ensure the appliance is away from any sources of heat (direct sunlight, electric stove, etc. [. . . ] Protect the food, (especially easily perishable items and those that have a strong smell), in order to avoid contact between them, thereby removing both the possibility of germ/bacteria contamination as well as the diffusion of strong odours inside the fridge. Store all food in such a way as to ensure air can circulate freely between different items. Setting the temperature The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. 1 = warmest MAX = coldest We recommend , however , a medium position. The cooling section of the refrigerator is located inside the back wall of the refrigerator compartment for increased space and improved aesthetics. During operation, the back wall will be covered in frost or water droplets depending on whether the compressor is operating or paused. Do not worry, the refrigerator is functioning normally. Chiller system PURE WIND It is recognizable due to the presence of the mechanism on the top part of the refrigerator compartment (see diagram). Keep the inside of your fridge clean, taking care not to use oxidiser or abrasive products. Remove all food past its expiry date from the refrigerator. For the correct preservation of food, all easily perishable items (soft cheeses, raw fish, meat, etc. Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. • The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. Avoiding mould and unpleasant odours • The appliance is manufactured with hygienic materials which are odour free. In order to maintain an odour free refrigerator and to prevent the formation of stains, food must always be covered or sealed properly. • If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. Clean and dry the freezer compartment carefully before switching the appliance on again. Until the ideal storage conditions have been restored, before placing food in the freezer compartment. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover (10 W, 15W or 25W). [. . . ] • Do not touch the appliance with bare feet or with wet or moist hands and feet. • Do not touch the internal cooling elements: cause skin abrasions or frost/freezer burns. This could Respecting and conserving the environment • Install the appliance in a fresh and well-ventilated room. Ensure that it is protected from direct sunlight and do not place it near heat sources. [. . . ]