Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual HASBRO SPIDER ATTACK. We hope that this HASBRO SPIDER ATTACK user guide will be useful to you.
Lastmanuals help download the user guide HASBRO SPIDER ATTACK.
Detailed instructions for use are in the User's Guide.
[. . . ] This symbol reminds you to read this booklet. 1
19508652900 TCD851 AX EU
21/9/10
11:56
Page 2
Important Information
GB
For your Condenser dryer to operate efficiently, you must follow the regular maintenance schedule shown below:
Fluff Filter. You MUST clean the fluff filter after EVERY drying cycle. Pull out the filter (using the two finger grips). [. . . ] Q
When is displayed, Automatic option is available if you change your mind. The last 3 minutes of these programmes is the Cool Tumble phase . Warning, after pressing the Start/Pause button , the programme cannot be changed. To change a selected programme, press the Start/Pause button , the light flashes Amber to indicate the programme is paused. Select the new programme and any options required, the light will then flash green. Press the Start/Pause button again and the new programme will start. Q
controller calculates a better estimate of the cycle time. The colons between the hours and minutes in the display flash to show that the time is counting down. The display also shows if there is a problem with your dryer, if this occurs the display will show F followed by a fault code number (see Troubleshooting). Q
Empty Water Container
Option buttons / icons These buttons are used to customise the selected programme to your requirements. A programme must have been selected, by pressing a programme selection button, before an option can be selected. The Start/Pause button must be pressed to resume the delay programme. the display will change to show current status. Q During the drying part of the programme, the colons on the display stop flashing to show that the time has stopped counting down. The Start/Pause button must be pressed to resume the programme. The display will change to show the current status, the colons flash and count down continues. Q During the Post Care phase, the programme ends. Pressing the Start/Pause button will restart a new programme from the beginning. Q
q
Heat Pump Protection System
The heat pump system has a compressor protection feature that operates if you open the door or there is a power disruption or if you turn off the dryer. This system will prevent the heat pump compressor from starting for 5 minutes after the door is closed and the programme is started. Q
Note If you have a power cut, switch off the power or remove the plug. When power is restored, press the Start/Pause button and the programme will resume. [. . . ] if F10 or F15 is still displayed contact the Service Centre (see Service). If any other number is shown: Note down the code and contact the Service Centre (see Service). the dryer is in ‘Demo’ mode. Press and hold both the On/Off and Start/Pause buttons for 3 seconds. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE HASBRO SPIDER ATTACK
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual HASBRO SPIDER ATTACK will begin.
