User manual HASBRO STIKFAS AFK-6 OMGA MALE ARMORED KNIGHT WITH STALLION

[. . . ] To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. • Positioning and levelling 1. Remove the appliance from all packaging and check that it has not been damaged during transportation. [. . . ] Press the DELAYED START button: every time the button is pressed, a beep is emitted and the selected delayed start indicator light illuminates. Select the wash cycle and shut the door: after the beep sounds, the timer begins counting down. Once this time has elapsed, the indicator light switches off and the wash cycle begins. To adjust the delay time and select a smaller period of time, press the DELAYED START button. To cancel it, press the button repeatedly until the selected delayed start indicator light switches off. The wash cycle will start automatically as soon as the door is shut. Modifying a wash cycle in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun: open the door, taking care to avoid the escaping steam, and press the WASH CYCLE SELECT button, holding it for 4 seconds. After one long beep and three short beeps, the WASH CYCLE indicator light will switch off: select the new wash cycle and start the programme by shutting the door. Adding extra crockery Open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Close the door: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • when the green float* cannot be seen by simply looking at the cap of the salt dispenser; • when the LOW SALT* indicator light on the panel flashes; • if your machine is not equipped with an indicator light or a The default setting of the water softening system is +. - If using multi-functional tablets fill the salt dispenser and set the adjuster to -; if the hardness of the water is greater than 60°fH, set it to +. 20 Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. €¢ Remove the plug from the socket when cleaning the machine and when carrying out maintenance work. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned. After cleaning check that the filter assembly has been replaced correctly. The dishwasher should not be used without filters or when the filter is loose. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under running water. EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a nonabrasive cloth which has been dampened with water. [. . . ] problem: The dishwasher does not start. €¢ • • • • • • • EN Possible causes / Solutions: • Th e plu g h as not b e en inse rted into the electrical socket prop erly, or there is n o p ow er in the h o use. Th e level of the refin ed salt is low or th e dosag e setting is n ot suite d to the har d ness of the w ater (see R inse aid a nd s alt). The racks are overloaded (see Loading the racks). [. . . ]