User manual HASBRO STIKFAS ALPHA GREEN

[. . . ] To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. • Positioning and levelling 1. Remove the appliance from all packaging and check that it has not been damaged during transportation. [. . . ] Normal Preliminary wash cycle for dishes while the load is awaiting completion with the dishes from the next meal. Environmentallyfriendly* wash cycle with low energy consumption levels, suitable for pans and dishes. 24 g (A) 3 g (B) No Yes Yes 2:00’ 27 g (A) 27 ml (A) No No Yes 1:33’ No Soak No No Yes No 0:12' 24 g (A) 3 g (B) 24 ml (A) 3 ml (B) No Yes Yes 2:25’ Note To make it easier to measure out the detergent, it is worth remembering that: 1 tablespoon = 15 grams of powder = approximately 15 ml of liquid 1 teaspoon = 5 grams of powder = approximately 5 ml of liquid * The Eco wash cycle adheres to the regulation EN-50242. Although it has a longer duration than other wash cycles it uses less energy and is les harmful to the environment. 19 Rinse aid and refined salt EN Only use products which have been specifically designed for dishwashers. do not use table salt or industrial salt , or washing up liquid. If using a multi-functional product it is not necessary to add rinse aid; however, we recommend that you add salt, especially if you live in an area where the water is hard or very hard. If you do not add salt or rinse aid, the LOW SALT* and LOW RINSE AID* indicator lights will flash continuously. Green float: approximately every 30 wash cycles; 1. Remove the lower rack and unscrew the cap of the dispenser (in an anti-clockwise direction). For the first wash cycle only: fill the dispenser up to the edges with water. It is therefore recommended that the arms are checked from time to time and cleaned with a small non-metallic brush. € The entire filter assembly should be C B cleaned thoroughly once a month: this includes the A semicircular plate A, the glass B and the cylinder C (this may be removed by turning it in an anti-clockwise direction). Use a small non-metallic brush to clean these parts. Reconstruct the filter assembly and replace it in the correct position, following movements 1 and 2 as shown in the figure, until it clicks into place. Leaving the machine unused for extended periods • Disconnect the appliance from the electricity supply and shut off the water tap. € Leave the door of the appliance ajar. € When you return, run a wash cycle when the dishwasher is empty. 21 Precautions and advice EN The appliance was designed and manufactured in compliance with current international safety standards. The following information has been provided for safety reasons and should therefore be read carefully. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. General safety • The appliance was designed for domestic use inside the home and is not intended for commercial or industrial use. [. . . ] Turn on the tap an d the appliance will start after a few minutes. No w ater drains out fro m the dishw asher. the dishw asher m akes excessive noise. The dishes and g lasses are covered in a w hite film or lim escale deposits. [. . . ]