User manual HASBRO STOP THIEF GERMAN052

[. . . ] • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance). The water pressure must be within the values indicated in the Technical data table (see adjacent information). [. . . ] Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. 18 Wash cycles If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. The number and type of wash cycles and options may vary depending on the dishwasher model. Preliminary wash cycle for dishes while the load is awaiting completion with the dishes from the next meal. Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Economic and fast wash to be used for lightly soiled dishes. (Run cycle immediately after use) (2 plates + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). Economic and fast wash for delicate items which are sensitive to high temperatures. (Run cycle immediately after use) (12 glasses + delicate plates). 30 g (A) Intensive 25 g (A) 5 g (B) Normal 30 ml (A) Yes 25 ml (A) 5 ml (B) 1 (A) Yes 1:45’ No Soak 25 g (A) 5 g (B) Eco* No No No 0:08’ 25 ml (A) 5 ml (B) 1 (A) Yes 2:20’ 25 g (A) 25 g (A) 1 (A) No 0:35’ Rapid 30 g (A) Crystal 30 g (A) 1 (A) Yes 1:30’ Notes: Optimum performance levels when using the ""Quick wash" cycle can be achieved by observing the maximum amounts of crockery specified. - Unscrew the end of the water inlet hose, remove the filter and clean it carefully under running water. - Replace the filter and screw the water hose back into position. • Turn off the water tap after every wash cycle to avoid leaks. • Always unplug the appliance when cleaning it and when performing maintenance work. • The external surfaces of the machine and the control panel may be cleaned using a non-abrasive cloth which has been dampened with water. do not use solvents or abrasive products. • Any marks on the inside of the appliance may be removed using a cloth dampened with water and a little vinegar. Cleaning the dishwasher Cleaning the filters The filter assembly consists of three filters which remove food residues from the washing water and then recirculate the water. They should be cleaned if you wish to achieve the best results in every wash. The dishwasher should not be used without filters, or if the filter is loose. • After several washes, check the filter assembly and if necessary clean it thoroughly under running water, using a non-metallic brush and following the instructions below: 1. [. . . ] €¢ The racks are over l oaded ( see Loadi ng the racks). • The crockery has n ot been arranged well. €¢ The spr ayer arms cannot move freel y. €¢ The wash cycl e is too gentl e (see Wash cycles). [. . . ]