User manual HASBRO STRATEGO DUEL MASTERS

[. . . ] chiud ere il ru binetto dell’acqu a pe r evita re allag a m enti , staccare la spina della corre nte e chiam are l’A ssisten za. • To a suitable hot water connection point: your dishwasher may be supplied with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance). [. . . ] After selecting the wash cycle, press the ShorTime option button; the illumination of the corresponding indicator light followed by a short beep indicates its selection. To deselect the option, press the same button again. 19 Wash cycles EN For available OPTIONS please refer to the Table of options on the Start-up and use page. The number and type of wash cycles and options may vary depending on the dishwasher model. Pre-wash for dishes while awaiting completion of the load with the dishes from the next meal. Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Economic and fast wash to be used for lightly soiled dishes. (Run cycle immediately after use) (2 plates + 2 glasses + 4 pieces of cutlery + 1 saucepan + 1 small frying pan). Economic and fast wash for delicate items which are sensitive to high temperatures. (Run cycle immediately after use) (12 glasses + delicate plates). W ash spread over the two racks: delicate for crystal and glasses on the upper rack and heavy duty for the pans on the lower rack. If this happens, clean the spill immediately with a dry cloth. NEVER pour the rinse aid directly G into the appliance tub. 5* For values between 0°f and 10°f, we do not recommend the use of salt. * this setting may cause a slight increase in the duration of the cycle. (°dH = hardness measured in German degrees - °f = hardness measured in French degrees - mmol/l = millimoles per litre) Measuring out the refined salt In order to achieve the best possible results using a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: • When the green float* cannot be seen by simply looking at the cap of the salt dispenser. • When the LOW SALT* indicator light on the control panel is illuminated; 1. Remove the lower rack and unscrew the cap of the dispenser (in an anti-clockwise direction). For the first wash cycle only: fill the dispenser up to the edges with water. Position the funnel* correctly (see figure) and fill the salt dispenser up to the edges (approximately 1 kg); it is normal for a little water to leak out. [. . . ] €¢ The dish washer do or has not been shut properly. €¢ The dishes are rattling against each other or against the sp rayer arm s. €¢ A n e x c e s s iv e a m o u n t o f f o a m h a s b e e n p r o d u c e d : t h e d e t e r g e n t h a s n o t been m easured out c orrectly or it is not suitable for us e in dish washers (s ee S tart-up and us e). The dishes and glasses are covered in a w hite film or lim escale deposits. [. . . ]