User manual HASBRO SUPER POWERS JLA SKYSCRAPER CAPER

[. . . ]  The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may cause harm to people and animals or may damage property. • If the appliance is to be installed above an oven, the oven must be equipped with a forced ventilation cooling system. • Avoid installing the hob above a dishwasher: if this cannot be avoided, place a waterproof separation device between the two appliances. [. . . ] To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Use the button repeatedly until the duration buttons to set the new duration. Booster function The booster function for some of the cooking zones may be used to shorten heating-up times. it may be activated by pressing the Booster button. The indicator you wish to change is shown. Light directly above the button will illuminate. This function boosts the power to 2000 W or 3000 W, depending on the size of the relevant cooking zone. The booster stops automatically after 4 minutes. While the booster for one of the cooking zones is active, the corresponding front or rear cooking zone will operate at a reduced power level (e. confirm by pressing the To cancel a programme , follow the above instructions. • Always use pans with a diameter which is large enough to cover the hotplate fully, in order to use all the available heat. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Press and hold the simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for + and buttons • Make sure that the base of the cookware is always clean and dry, in order to fully utilise and extend the life of both the cooking zones and the cookware. • Avoid using the same cookware which has been used on gas burners: the heat concentration on gas burners may distort the base of the pan, 28 causing it not to adhere correctly. GB Power level 1 2 3 4 5 6 7 8 9 Maximum operating time in hours 9 8 7 6 5 4 3 2 1 Safety devices Pan sensor Each cooking zone is equipped with a pan sensor device. The hotplate only emits heat when a pan with suitable measurements for the cooking zone is placed on it. If the indicator light is flashing, it may indicate: • An incompatible pan • A pan whose diameter is too small • The pan has been removed from the hotplate. [. . . ] Exhausted appliances should be collected separately in order to optimise the cost of re-using and recycling the materials inside the machine, while preventing potential damage to the atmosphere and to public health. The crossedout dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. 31 Care and maintenance GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. [. . . ]