User manual HASBRO SUPER TREAT CENTER RECIPE BOOK

[. . . ] Pass them on to possible new owners of the appliance. Fixing The appliance must be installed on a perfectly level supporting surface. Any deformities caused by improper fixing could change the features and the operation of the hob. fRONT SIDE OF HOB SUPPORTING SURFACE 30 Positioning ! [. . . ] circular extendable hotplate Oval extendable hotplate DOUBLE HOTPLATE ON indicator light TRIPLE HOTPLATE ON indicator light DOUBLE HOTPLATE ON indicator light DOUBLE HOTPLATE ON button TRIPLE HOTPLATE ON button DOUBLE HOTPLATE ON button • DOUBLE HOTPLATE ON button switches on the double hotplate (see Start-up and use). • DOUBLE HOTPLATE ON indicator light shows the double hotplate has been switched on. TRIPLE HOTPLATE ON button switches on the triple hotplate (see Start-up and use). • TRIPLE HOTPLATE ON indicator light shows the triple hotplate has been switched on. 18 Start-up and use  The glue applied on the gaskets leaves traces of grease on the glass. Before using the appliance, we recommend you remove these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. switching on the extendable cooking zones • Double hotplate: 1. Press the button to switch on the smaller internal cooking zone. If the second cooking zone is circular: press button to switch on (or off) the second the cooking zone. If the cooking zone is circular: Press the button to switch on (or off) the whole cooking zone (triple hotplate). The timer begins counting down immediately. When the set programme has finished, a buzzer sounds for about 10 seconds and the cooking zone switches off. Repeat the above procedure for each hotplate you wish to programme. Using multiple programmes and the display If one or more hotplates are programmed, the display will show the data for the hotplate with the least time remaining, and the light corresponding to the position of the hotplate will be switched on. The lights corresponding to the other hotplates programmed will flash. To display the time remaining for the other programmed hotplates, press the button repeatedly. The times remaining for each hotplate will be shown in a clockwise order, beginning with the front left hotplate. Press the button repeatedly until the time you wish to change is shown. Confirm by pressing the To cancel a programme, follow the above instructions. When it comes to point 2, press the buttons simultaneously. The setting will return to zero and the display will no longer be operating in the programme setting mode. [. . . ] The crossed-out dustbin is marked on all products to remind the owner of their obligations regarding separated waste collection. For further information relating to the correct disposal of exhausted household appliances, owners may contact the public service provided or their local dealer. 22 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Stainless steel frame (only in models with outer frame) Stainless steel can be marked by hard water which has been left on the surface for a long time, or by cleaning products containing phosphorus. [. . . ]