User manual HASBRO TATTLER QUIZ QUESTIONS BOOKLET

[. . . ] Connecting the water inlet hose • To a suitable cold water connection point: before attaching the hose, run the water until it is perfectly clear so that any impurities that may be present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. Remove the appliance from all packaging and check that it has not been damaged during transportation. [. . . ] Press the ON/OFF button again: the cycle starts from the point at which it was interrupted. Washing options Delayed start It is possible to delay the start time of the cycle by 12, 9, 6 or 3 hours. Press the DELAYED START button: every time the button is pressed, a beep is emitted and the selected delayed start indicator light illuminates. Select the wash cycle and press the START/RESET button: after the beep sounds, the timer begins counting down. Once this time has elapsed, the indicator light switches off and the wash cycle begins. To adjust the delay time and select a smaller period of time, press the DELAYED START button. To cancel it, press the button repeatedly until the wash cycle begins and the WASH CYCLE PHASE indicator light corresponding to the start of the cycle in progress illuminates. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. 18 Wash cycles Wash cycle table Ariston dishwashers are fitted with an automatic filter cleaning system that may increase the cycle duration. The number and type of wash cycles and options may vary depending on the dishwasher model. The salt dispenser is located in the lower part of the dishwasher (see Description) and should be filled: * Only available in selected models. 20 Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. • Remove the plug from the socket when cleaning the machine and when carrying out maintenance work. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned. After cleaning check that the filter assembly has been replaced correctly. The dishwasher should not be used without filters or when the filter is loose. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a cloth dampened with warm soapy water. do not use solvents or abrasive products. • Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. [. . . ] Th e filter is dirty o r blocke d (see C are a n d m a inten a n ce). Turn o n th e tap an d the ap plia nce w ill start after a fe w m in utes. No w ater drains out fro m the dishw asher. The dishes and g lasses are streaked or ha ve a b luis h tinge. [. . . ]