User manual HASBRO TINKERTOY CRAZY CONSTRUCTIONS

[. . . ] Make sure that the instructions are kept with the appliance if it is sold, given away or moved. Ventilation To ensure adequate ventilation is provided, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). Positioning  Keep all packaging materials out of the reach of children. [. . . ] BARBECUE mode The top heating element and the rotisserie spit (where present) are activated. By pressing the “+” and “-” buttons on the left hand side of the control panel, the power levels that may be set will appear on the TEMPERATURE display; these range between 5% and 100%. The high and direct temperature of the grill is recommended for food which requires a high surface temperature. Always cook in this mode with the oven door closed. GRATIN mode The top heating element and the rotisserie spit (where present) are activated and the fan begins to operate. During part of the cycle the circular heating element is also activated. This combination of features increases the effectiveness of the unidirectional thermal radiation of the heating elements through forced circulation of the air throughout the oven. This helps prevent food from burning on the surface and allows the heat to penetrate right into the food. Always cook in this mode with the oven door closed. LOW TEMPERATURE modes This type of cooking can be used for proving, defrosting, preparing yoghurt, heating dishes at the required speed and slow cooking at low temperatures. Place the rotisserie support in position 3 and insert the spit into the hole provided on the back panel of the oven. Press the "+" and "-" buttons to adjust the hour value. Press the digits on the TIME display begin to flash. Press the "+" and "-" buttons to adjust the minute value. And a time of 1 hour and 15 minutes is programmed. Programming delayed cooking  A cooking duration must be selected before delayed programming can take place. Follow steps 1 to 5 to set the duration as detailed above. Then press the button until the icon and the two digits on the TIME display flash. Press the "+" and "-" buttons to adjust the hour value. Press the digits on the TIME display begin to flash. Press the "+" and "-" buttons to adjust the minute value. And a time of 1 hour and 15 minutes is programmed and the end time is set to 12:30. [. . . ] Inspecting the seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced. Replacing the light bulb To replace the oven light bulb: Cleaning the oven door Clean the glass part of the oven door using a sponge and a non-abrasive cleaning product, then dry thoroughly with a soft cloth. [. . . ]