User manual HASBRO TOY STORY AND BEYOND LASER BLASTIN BUZZ LIGHTYEAR

[. . . ]  The appliance must be installed by a qualified professional in accordance with the instructions provided.  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanently ventilated rooms, in accordance with current national legislation and any subsequent amendments in force. The room in which the appliance is installed must be ventilated adequately in order to provide as much air as is needed by the normal gas combustion process (the flow of air must not be lower than 2 m3/h per kW of installed power). [. . . ] Turn the knob to the minimum position (MIN) after it has been in the maximum position (MAX) for approximately 10 minutes. Tighten or loosen the adjustment screws on the outside of the thermostat pin (see figure) until the flame is small but steady.  If the appliance is connected to natural gas, the adjustment screw must be loosened in an anticlockwise direction. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished.  Be careful of the spark plug wires and the thermocouple tubes.  The oven burner does not require primary air adjustment.  After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one which corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres).  Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”. 78 MJ/m3 19 Description of the appliance G B Overall view Hob grid Auxliary gas burner Triple ring gas burner Rapid gas burner 80 0 0 -9 0 Semi-rapid gas burner Control panel Control panel 20 Start-up and use Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. To light the burner, press the knob in fully and turn it in an anticlockwise direction until it reaches position 8. Given that the oven is fitted with a safety device, after the burner has been lit the oven knob should be held in that position for approximately 6 seconds, in order to allow the gas to pass through until the safety thermocouple heats up. The electronic oven burner ignition device should not be activated for more than 15 seconds. The grill is also highly recommended for dishes that require a high surface temperature: such as beef steaks, veal, rib steak, fillets, hamburgers etc. The grill is controlled by a thermostat which adjusts its operation. By turning the oven knob until it reaches the position, the rotisserie spit motor is activated as well as the infrared grill. This motor will remain active as long as the grill is operating. Oven light The light may be switched on at any moment by pressing the OVEN LIGHT button. timer To activate the Timer proceed as follows: 1. Turn the TIMER knob in a clockwise direction " for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction # to set the desired length of time. [. . . ] • Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 24 Care and maintenance Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. [. . . ]