User manual HASBRO TRANSFORMER FUZORS MAXIMAL RATTRAP

[. . . ]  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Levelling If it is necessary to level the appliance, screw the adjustable feet into the positions provided on each corner of the base of the cooker (see figure). The legs* fit into the slots on the underside of the base of the cooker. Positioning and levelling  The appliance may be installed alongside any cupboards whose height does not exceed that of the hob surface. [. . . ] • Crackle: produced by the vibration of materials on the bottom of the pot due to the flow of parasitic currents caused by electromagnetic fields (induction); can be more or less intense depending on the material making up the bottom of the pot, and decreases as the pot dimensions increase. • Loud whistle: heard when two induction elements of the same group function simultaneously at maximum power and/or when the booster function is set on the larger element while the other is auto-adjusted. Noise is reduced by decreasing the power level of the autoadjusted induction element; pot bottom layers made of different kinds of materials are among the main causes of this noise. • Fan noise: a fan is necessary to ensure the hob functions correctly and to safeguard the electronic unit from possible overheating. The fan functions at maximum power when the large induction element is at maximum power or when the booster function is on; in all other cases, it works at average power depending on the temperature detected. Furthermore, the fan may continue to work even after switching the hob off, if the temperature detected is high. The types of noise listed above are due to induction technology and are not necessarily operational faults.  If the Switching on the hob To switch the hob on, press and hold the for approximately one second. Booster function* The booster function for some of the cooking zones may be used to shorten heating-up times. it may be activated by pressing the Booster button. The indicator light directly above the button will illuminate. Switching off the hob Press the button to switch the appliance off. If the control panel lock has been activated, the controls will continue to be locked even after the hob is switched on again. In order to switch the hob on again, you must first remove the lock function. “Demo” mode It is possible to set the hob to a demonstration mode where all the controls work normally but the heating elements do not switch on. To activate the “demo” mode the hob must be switched on, with all the hotplates switched off. • Press and hold the simultaneously for 6 seconds. When the 6 seconds have elapsed, the ON/OFF and CONTROLS LOCKED indicator lights will flash for one second. Release the press the button; you wish to change is shown. At step 2, press the duration decreases progressively until it reaches 0 and switches off. The programme resets and the display exits programming mode. - + and buttons button: the + and buttons and Timer The hob must be switched on. [. . . ] The programme may only be started once the oven door has been closed. To activate the PYROLITIC CYCLE cleaning procedure, press and hold the button for approximately 4 seconds. The TIMER KNOB may be used to select the desired cleaning level; there are three default time settings which cannot be modified. Economy (ECO): turn the knob towards “-”. [. . . ]