User manual HASBRO TRANSFORMERS ARMADA DEMOLISHOR WITH BLACKOUT 80849 80702

[. . . ]  The appliance must be installed by a qualified professional according to the instructions provided.  Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanentlyventilated rooms, according to current national legislation. The room in which the appliance is installed must be ventilated adequately so as to provide as much air as is needed by the normal gas combustion process (the flow of air must not be lower than 2 m3/h per kW of installed power). [. . . ] Adapting the hob Replacing the nozzles for the hob burners: 1. Remove the hob grids and slide the burners off their seats. Unscrew the nozzles using a 7 mm socket spanner (see figure), and replace them with nozzles suited to the new type of gas (see Burner and nozzle specifications table). Replace all the components by following the above instructions in reverse. Unscrew the nozzle using a special nozzle socket spanner (see figure) or with a 7 mm socket spanner, and replace it with a new nozzle that is suited to the new type of gas (see Burner and nozzle specifications table). Turn the knob to the minimum position (MIN) after it has been in the maximum position (MAX) for approximately 10 minutes. Tighten or loosen the adjustment screws on the outside of the thermostat pin (see figure) until the flame is small but steady. 16  If the appliance is connected to liquid gas, the regulation screw must be fastened as tightly as possible. TECHNICAL DATA Oven Dimensions HxWxD Volume Useful measurements relating to the oven compartment Voltage and frequency 31x41x41 cm 58l GB width 46 cm depth 42 cm height 8, 5 cm see data plate may be adapted for use with any type of gas shown on the data plate. eC Directives 2006/95/EC dated 12/12/06 (Low Voltage) and subsequent amendments 04/108/EC dated 15/12/04 (Electromagnetic Compatibility) and subsequent amendments 2009/142/EC dated 30/11/09 (Gas) 1275/2008(Stand-by/Off-mode) 5. Turn the knob from the MAX position to the MIN position quickly or open and shut the oven door, making sure that the burner is not extinguished. Using the oven  Before operating the product, remove all plastic film from the sides of the appliance.  The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may emit a slightly unpleasant odour caused by protective substances used during the manufacturing process burning away. Place the rotisserie support in position 4 and insert the spit in the hole provided on the back panel of the oven. Turn the TIMER knob in a clockwise direction " for almost one complete revolution to set the buzzer. Turn the TIMER knob in an anticlockwise direction # to set the desired length of time. 4 Rack position 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 3 4 4 3 4 4 Preheating time (min) 10 10 10 10 10 10 10 10 10 10 10 10 15 15 15 15 15 5 5 5 5 5 Recommended temperature (°C) 210 200 200 200 220 200 200 200 200 180-200 180-200 180-200 220 180 180 180 180 Cooking time (minutes) 60-75 40-50 40-50 85-90 90-100 100-110 70-80 70-80 90-95 35-40 40-50 40-45 15-20 30-35 30-35 45-50 35-40 15-20 20 7 15-20 5 GB Assembling the sliding rack kit To assemble the sliding racks: 1. Remove the two frames, lifting them away from the spacers A (see figure). Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame. [. . . ] • Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door, thus avoiding heat dispersion. 22 Care and maintenance 08/2010- 195085201. 00 XEROX FABRIANO Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the oven seals Check the door seals around the oven regularly. [. . . ]