User manual HASBRO TRANSFORMERS ARMADA DEMOLISHOR WITH BLACKOUT MINI CON

[. . . ] Make sure that the instructions are kept with the appliance if it is sold, given away or moved. The appliance must be installed by a qualified professional according to the instructions provided. Any necessary adjustment or maintenance must be performed after the cooker has been disconnected from the electricity supply. Room ventilation The appliance may only be installed in permanentlyventilated rooms, according to current national legislation. [. . . ] Be careful of the spark plug wires and the thermocouple tubes. The oven and grill burners do not require primary air adjustment. After adjusting the appliance so it may be used with a different type of gas, replace the old rating label with a new one that corresponds to the new type of gas (these labels are available from Authorised Technical Assistance Centres). Should the gas pressure used be different (or vary slightly) from the recommended pressure, a suitable pressure regulator must be fitted to the inlet hose in accordance with current national regulations relating to “regulators for channelled gas”. V TECHNICAL DATA Oven dimensions (HxWxD) Volume Useful measurements relating to the oven compartment Power supply voltage and frequency 34x38x44 cm 57 l width 42 cm depth 44 cm height 17 cm see data plate may be adapted for use with any type of gas shown on the data plate, which is located inside the flap or, after the oven compartment has been opened, on the left-hand wall inside the oven. = 37, 78 MJ/m³ 17 Descriptionof the appliance GB Overall view Gas burner Hob grid Control panel Containment surface for spills GUIDE RAILS for the sliding racks position 5 position 4 position 3 position 2 position 1 Adjustable foot GRILL DRIPPING PAN Adjustable foot Control panel OVEN control knob Hob BURNER control knobs ELETTRONIC TIMER* * Only available in certain models. 18 Start-up and use Using the hob Lighting the burners For each BURNER knob there is a complete ring showing the strength of the flame for the relevant burner. To light one of the burners on the hob: 1. Bring a flame or gas lighter close to the burner. Press the BURNER knob and turn it in an anticlockwise direction so that it is pointing to the maximum flame setting . Adjust the intensity of the flame to the desired level by turning the BURNER knob in an anticlockwise direction. To replace it, lock it in place with the screw S. Place the rotisserie support in position 4 and insert the spit in the hole provided on the back panel of the oven. Activate the rotisserie with the OVEN control knob. Before using the oven make sure that the sliding protection is fixed correctly. 20 Electronic timer* The electronic timer displays the time and the timer function with countdown. This may be set while the oven is switched off or while it is switched on. Press the button several times until the icon and the first two numerical digits on the display start to flash. Use the “+” and “-” buttons to adjust the hour value. Press the button again so that the other two numerical digits on the DISPLAY begin to flash. Use the “+” and “-” buttons to adjust the minute value. If none of the buttons are pressed, the settings will be confirmed automatically after 10 seconds have passed. [. . . ] Inspecting the oven seals Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest Authorised After-sales Service Centre. We recommend that the oven is not used until the seals have been replaced. Do not use abrasive or corrosive detergents such as stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. [. . . ]