User manual HASBRO TRANSFORMERS BEAST WARS PREDACON SCORONOK

[. . . ] The cable must not be bent or compressed. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). The manufacturer declines any liability should these safety measures not be observed. 10 Description of the appliance Overall view The instructions contained in this manual are applicable to different model refrigerators. [. . . ] 1 = warmest 5 = coldest We recommend , however , a medium position. The cooling section of the refrigerator is located inside the back wall of the refrigerator compartment for increased space and improved aesthetics. During operation, the back wall will be covered in frost or water droplets depending on whether the compressor is operating or paused. Do not worry, the refrigerator is functioning normally. If the TEMPERATURE ADJUSTMENT knob has been set on high values with large quantities of food and with a high ambient temperature, the appliance can operate continuously, resulting in excessive frost formation and excessive energy consumption: compensate for this by shifting the knob towards lower values (defrosting will occur automatically). In static appliances, the air circulates in a natural way: the colder air tends to move downwards as it is heavier. The food should be stored as follows: $UUDQJHPHQW LQVLGH WKH )RRG UHIULJHUDWRU Above the fruit and vegetable Fresh fish and meat bins Above the fruit and vegetable Fresh cheese bins Cooked food On any shelf Salami, bread loaf, chocolate Fruit and vegetables Eggs On any shelf In the fruit and vegetable bins On the shelf provided Butter and margarine On the shelf provided Bottles, drinks, milk On the shelf provided 12 Maintenance and care Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. The refrigerator has an automatic defrosting function: water is ducted to the back of the appliance by a special discharge outlet (see diagram) where the heat produced by the compressor causes it to evaporate. It is necessary to clean the discharge hole regularly so that the water can flow out easily. GB Cleaning the appliance • The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. Replacing the light bulb To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. • Do not fill the appliance with too much food: cold air must circulate freely for food to be preserved properly. If circulation is impeded, the compressor will work continuously. • Do not place hot food directly into the refrigerator. The internal temperature will increase and force the compressor to work harder and will consume more energy. • Defrost the appliance if ice forms (see Maintenance). A thick layer of ice makes cold transference to food products more difficult and results in increased energy consumption. • Regularly check the door seals and wipe clean to ensure they are free of debris and to prevent cold air from escaping (see Maintenance). • When unplugging the appliance always pull the plug from the mains socket, do not pull on the cable. • Before cleaning and maintenance, always switch off the appliance and disconnect it from the electrical supply. It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. • In the case of a malfunction, under no circumstances should you attempt to repair the appliance yourself. [. . . ] • The food is in contact with the back inside wall of the refrigerator. ╠The door is not closed properly or is continuously opened. • The outside ambient temperature is very high. • The appliance has not been installed on a level surface (see Installation). [. . . ]